Abstract:This paper studies the dynamics of an atomic force microscopy (AFM) cantilever that is considered to be operating under continuous viscoelastic surface contact with material profiles based on the modified nonlocal theory of elasticity. The contact between the cantilever's tip and the sample surface is modeled using a linear stiffness–damper pair and a lumped mass at the beam's free end. The higher-order partial differential equation (PDE) governing the AFM nanocantilever transverse motion and its associated higher-order boundary conditions (BCs) are derived employing extended Hamilton's principle based on the nonlinear nonlocal higher-order constitutive relation in Euler–Bernoulli beam model. The Galerkin's decomposition method is applied to discretize the higher-order PDE and BCs of motion into a set of ordinary differential equations (ODEs) via the mode summation technique using eigenfunctions (mode shapes) of a classic cantilever thin beam. Then, using state-space form of ODEs of motion the frequency analysis is performed based on the eigenvalues of vibration motion. The obtained results are validated with the literature works. The impact of various parameters including nonlocal nanoscale elasticity parameter, added point mass, contact stiffness and viscous damping factors and the specific position where the concentrated mass and the contact stiffness–damper pair are attached to the beam on the resonant frequencies of AFM cantilever is comprehensively investigated. Numerical simulations showed that the resonance frequencies of the AFM cantilever increase by increasing the value of nonlocal nanoscale parameter. Also, it was concluded that an increase in the nonlocal parameter and surface contact stiffness leads the AFM cantilever to be more stiffened. Moreover, it was seen that by increasing the position distance of lumped mass on the beam and contact spring–damper pair from the beam's fixed end, the resonant frequency reduction in the larger values of the surface contact stiffness is more noticeable.

Experiments on the Deformation of MEMS Mciro-Cantilever Using AFM

Large Deformation Mechanical Modeling with Bilinear Stiffness for Macro-Fiber Composite Bimorph Based on Extending Mixing Rules

An updated model including the deflection history of microcantilever for characterizing cellular viscoelastic properties by AFM indentation-relaxation test

Calibration of the Effective Spring Constant of Ultra-Short Cantilevers for A High-Speed Atomic Force Microscope

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Static Nano-Control Of Cantilever Beams Using The Inverse Flexoelectric Effect

Calibration of the spring constant of AFM micro-cantilever based on bending method

Research Progress on the Calibration Methods for Elastic Constant of Atomic Force Microscopy Cantilevers

Dimension effect on mechanical behavior of silicon micro-cantilever beams

Multiflexoelectric Actuation and Control of Beams

On Micro Scanning Forces under the Coupling Deformation of Atomic Force Microscope Probe

Performance analysis of Micro-cantilever beams and sensor data fitting

Micro-mechanical Characterisation for MEMS Thin Films by Bending Μ-Machined Cantilevers

Finite Deformation Mechanics In Buckled Thin Films On Compliant Supports

Flexural resonant frequencies of an AFM cantilever in viscoelastic surface contact mode using modified nonlocal elasticity theory

Atomic Simulation of the Bending Deformation of A Single-Crystal Simply Supported Nano-Beam

Improved Calibration System of Micro-Cantilever Spring Constant

Design, modeling and experimental validation of a micro cantilever beam with an electro-controllable twisting ability

A comprehensive study of AFM stiffness measurements on inclined surfaces: theoretical, numerical, and experimental evaluation using a Hertz approach

Deformation analysis in microstructures and micro-devices

Nonlinear deformation analysis of magneto-electro-elastic nanobeams resting on elastic foundation by using nonlocal modified couple stress theory