Abstract:Microstructure evolution and fracture behavior of Mg-9.5Gd-0.9Zn-0.5Zr alloy subjected to different heat treatments were systematically investigated using SEM and TEM as well as tensile testing. It was found that the microstructure of the as-cast alloy consisted of α-Mg matrix, net-like eutectic compounds (α-Mg + Mg3 (Gd, Zn)), cubic GdH2 phases and lamellar 14H LPSO phases. After solution treated at 515 °C for 24 h, two different cooling processes were used to elucidate the effect of cooling rates on the precipitation microstructure. With a hot water quenching, those secondary phases were completely dissolved. Instead, grey-like patches were observed within the α-Mg matrix, which were proposed to be rod-like Zn2Zr3 phases around the α-Zr particle. In contrast, with a furnace cooling, the formation of 14H LPSO and several cubic Mg3 (Gd, Zn) phases was observed. Furthermore, after hot water quenching, the subsequent ageing treatment parameters were also optimized to be 225 °C for 48 h. In the peak-aged condition, a denser and uniform distribution of basal precipitates γ″ and several basal precipitates γ′ together with Zn2Zr3 and ZnZr2 phases were observed. The samples after the solution treatment (for both hot water quenching and furnace cooling) showed a much higher ductility than the as-cast alloy, while the tensile yield strength (TYS) and ultimate tensile strength (UTS) remained unchanged. After the peak-ageing, a significant increase in the TYS and UTS but a great loss in ductility was observed. In the as-cast alloy, the initiation of microcracks occurred from the net-like eutectic compounds, which was believed to be one of the most important reasons for the tensile fracture, and showed a co-existence of intergranular and transgranular fracture behavior. After the solution treatment, with a hot water quenching, the fracture can be mainly related with failures along contraction twins, and then showed a transgranular fracture behavior. While, with a furnace cooling, due to the presence of the kinked 14H LPSO phases, the fracture was caused by the broken of 14H LPSO phases, and then lead to a transgranular fracture. The peak-aged alloy exhibited a brittle intergranular fracture, which can be related with failures along soft precipitation free zones (PFZs).

Microstructure and Mechanical Properties of Heat Affected Zone in Multi-Pass GMA Welded Al–Zn–Mg–Cu Alloy

Microstructure and Impact Mechanical Properties of Multi-Layer and Multi-Pass TIG Welded Joints of Al−Zn−Mg Alloy Plates

Microstructure and Mechanical Properties of Multi-Pass TIG Welded Joint of Thick Al–Zn–Mg Alloy Plate

Microstructure evolution of HAZ in the multi-pass underwater wet welded joints

Microstructural and Mechanical Inhomogeneity in the Narrow-Gap Weld Seam of Thick GMA Welded Al–Zn–Mg Alloy Plates

Effect of aging state on microstructure and properties of heat affected zone in Al–Mg–Si–Cu alloy welded joints

Microstructure and Properties of Coarse Grain Zone in Single-Pass Welding of V-N Microalloyed Steel

Microstructural evolution and its effect on mechanical properties in different regions of 2219-C10S aluminum alloy TIG-welded joint

Microstructure evolution and fracture behavior of Mg-9.5Gd-0.9Zn-0.5Zr alloy subjected to different heat treatments

Strength calculation and microstructure characterization of HAZ softening area in 6082-T6 aluminum alloy CMT welded joints

Comparison of Microstructure and Mechanical Properties of TIG and Laser Welding Joints of a New Al–Zn–Mg–Cu Alloy

Overlapping Features and Microstructures of Coarse Grain Heat-Affected Zones in Swing Arc Narrow Gap GMA Welded EH40 Grade Steels

Microstructures and Mechanical Properties of Al–Zn–Mg Aluminium Alloy Samples Produced by Wire + Arc Additive Manufacturing

Microstructure Characterization of the Fusion Zone of an Alloy 600-82 Weld Joint

Microstructures in CGHAZ and Mechanical Properties of Welded Joint During Welding of Fine Grain Titanium Alloy

Effect of softening of 6082-T6 aluminum alloy CMT welded joints on mechanical properties and fracture behavior

Microstructures and Mechanical Properties of Al-Zn-Mg-Cu Alloys under Multi-Directional Severe Strain and Aging

Microstructure and Mechanical Properties of Simulated Unaltered Coarse Grained Heat Affected Zones of 10crni3mov Steel by Double-Sided Double Arc Welding

Mechanism of Interfacial Microstructure Evolution of G115 Steel in Simulated Heat Affected Zone

Microstructure-Based Modeling of the PMZ Mechanical Properties in 2219-T8 Aluminum Alloy TIG Welding Joint

Microstructure and Local Mechanical Properties of the Heat-Affected Zone of a Resistance Spot Welded Medium-Mn Steel