Abstract:The use of welded I-section steel members with longitudinally profiled (LP) steel plates is becoming popular in structures, and such members are manufactured with variable thickness to accommodate the loading distributions in practical construction. Compared with the constant thickness steel plates, the use of LP steel plates is more susceptible to local buckling at the thinner end. However, there was no study that reported the local buckling behaviour of such members. Furthermore, existing design codes do not provide any design guidance for calculating the strength of such steel members. In this paper, a total of sixteen welded I-shaped section stub columns with LP and constant thickness steel plates under axial compression were tested to study the local buckling behaviour of such members. The initial geometric imperfections of all specimens were measured using 3D laser scanning technology prior to the axial compression experiments. A nonlinear finite element (FE) model was also established, and validated against the corresponding experimental results, which showed a good agreement both in terms of ultimate strength and failure modes. An extensive parametric study including 130 FE models was conducted using validated FE models. To evaluate the feasibility and reliability of the existing design provisions for steel members with constant thickness steel plates, the test and numerical results were compared against design strength predicted from the existing design provisions. Upon comparison, the existing design formulas in Chinese Standard (GB 50017-2017), American Specification (ANSI/AISC 360-10) and European Standard (BS EN 1993-1-5) are found to be generally conservative when calculating the strength of such members with LP steel plates. New design formulas are proposed, in which the modified normalized slenderness ratio and enhancement coefficient are applied to the existing design provisions.

Experimental research on stainless steel welded I-section beam-columns

Compression tests on local buckling behavior of welded stainless steel Ⅰ-section stub columns

EXPERIMENTAL STUDY ON THE SEISMIC BEHAVIOR OF CFST RECTANGULAR COLUMN TO H-SECTION STEEL BEAM CONNECTIONS WITH EXTERNAL STIFFENERS

Global Buckling of S35657 Austenitic Stainless Steel Welded Box- and I-section Long Columns under Axial Compression

Flexural Buckling Behavior of Welded Stainless Steel Box-Section Columns

Local–overall Interactive Buckling Behaviour of Welded Stainless Steel I-section Columns

Experimental Study on Lateral Buckling Behavior of Stainless Steel Beams with Welded I-sections

Experimental investigation of concrete-filled steel tubular columns with reinforcing lattice angle

Experimental study of lateral-torsional buckling behavior of stainless steel welded I-section beams

Design of Austenitic and Duplex Stainless Steel SHS and RHS Beam-Columns

Austenitic Stainless Steel I‐section Beam‐column Tests and Numerical Modelling

Experimental and numerical investigation on Local-Overall interactive buckling behavior of welded I-Section steel columns

Experimental and Numerical Studies on Hysteretic Behaviour of Stainless Steel Welded Box-Section Columns

Experimental and Analytical Study on Local Buckling Behavior of High Strength Steel Welded I-Section Beams

Behavior of Eccentrically Loaded Large-Scale CFST Slender Columns with Latticed Annular Steel

Analysis of Flexural Buckling Capacity of Stainless Steel Columns under Axial Compression

Experimental study on I section steel beam-columns strengthened by welding while under load

Flexural buckling of cold-formed austenitic stainless steel flat-oval hollow section columns: Testing, modelling and design

Experimental and numerical investigation on flexural-torsional buckling of Q460 steel beams

Local buckling behaviour of welded I-section steel stub columns with longitudinally profiled steel plates under axial compression: Testing, modelling and design

S600E high-strength stainless steel welded section columns: Bearing capacity test and design method