Abstract:For structural health monitoring of large bridges,the traditional manual detection is inadequate because of its strong subjectivity,bad entirety and bad timeliness.The widely used wired health monitoring system also has some problems in the actual applications.For example,it is hard to wire in some area and it is easy to be affected by environment.Using wireless sensor networks in bridge structural health monitoring not only retains the advantage of wired health monitoring system but also makes up for its deficiencies in the applications.The paper describes the composition of the whole system,and discusses the composition of wireless sensor nodes in the monitoring area of the system.Through studying the composition of base station,the paper gives the role of base station in the health monitoring system.On the basis of the composition of wireless sensor nodes,the paper addresses the mean value drift of the accelerometer output resulting from temperature changes.It gives a method to calibrate the output value of using temperature compensation technology.In order to verify this method,we give a comparison between uncorrected accelerometer readings and corrected accelerometer readings.Then,through proposing the necessity of time synchronization of all nodes before data collection,the paper discusses the principle of time synchronization.At last,we built a health monitoring system which was composed by data collection,data transmission,data reception and data analysis.And we tested the system in the anchor cable of Runyang Yangtze River Bridge.We installed the wireless sensor node in the anchor cable and obtained its vibration information through accelerometer.Then these data was sent to the base station,and to monitoring center in final.By analyzing these data,the vibration frequency spectrum of anchor cables could be obtained.Through analyzing the frequency,the strength of bridge's cables would be figured out.It is useful to identify if the bridge is in a healthy status.If the data deviates from the normal range,the monitoring center will respond in time.At last,the paper gives a conclusion that the wireless system is suitable for bridge structural health monitoring field and useful for actual application.

Design and application of wireless cable tension sensor in the structure monitoring system of bridges

Design And Testing Of A Wireless Strain Sensor Toward Large-Span Spatial Structures

Design and Experimental Investigations of a Vibration Based Wireless Measurement System for Bridge Cable Tension Monitoring

Wireless sensor network based cable tension monitoring for cable-stayed bridges

Development Of A Customized Wireless Sensor System For Large-Scale Spatial Structures And Its Applications In Two Cases

Application of Wireless Cable Force Measurement System of Cable Structures

A wireless smart sensor network for automated monitoring of cable tension

Smart wireless tension force monitoring system for stay cables

Development of Elasto-Magneto-Electric (eme) Sensor for In-Service Cable Force Monitoring

Automated Wireless Monitoring System for Cable Tension Using Smart Sensors

Development of an Automated Wireless Tension Force Estimation System for Cable-Stayed Bridges

Design of the wireless system for health monitoring of a large span gymnasium structure

Development and Application of a Low-cost Automated Wireless Tension Estimation System for Cable Structures

Multi-channel fiber optical sensing system for urban bridge cluster health monitoring

Development of a Low-Cost Automated Tension Estimation System for Cable-Stayed Bridges

A new method for bridge structural health monitoring based on wireless sensor networks

Study on Health Monitoring System Design of Cable-Stayed Bridge

Special Collection: Towards Smart Buildings and Structures: Condition Monitoring, Assessment and Control Autonomous Main-Cable Vibration Monitoring Using Wireless Smart Sensors for Large-Scale Three-Pylon Suspension Bridges: A Case Study

Wireless Sensing Technologies for Bridge Monitoring and Assessment

Autonomous structural health monitoring using wireless smart sensors on a cable-stayed bridge

A Study on Building Wireless Acceleration Sensor Network for Global Monitoring on Cable-Stayed Bridge of Songhua River