Abstract:For structural health monitoring of large bridges,the traditional manual detection is inadequate because of its strong subjectivity,bad entirety and bad timeliness.The widely used wired health monitoring system also has some problems in the actual applications.For example,it is hard to wire in some area and it is easy to be affected by environment.Using wireless sensor networks in bridge structural health monitoring not only retains the advantage of wired health monitoring system but also makes up for its deficiencies in the applications.The paper describes the composition of the whole system,and discusses the composition of wireless sensor nodes in the monitoring area of the system.Through studying the composition of base station,the paper gives the role of base station in the health monitoring system.On the basis of the composition of wireless sensor nodes,the paper addresses the mean value drift of the accelerometer output resulting from temperature changes.It gives a method to calibrate the output value of using temperature compensation technology.In order to verify this method,we give a comparison between uncorrected accelerometer readings and corrected accelerometer readings.Then,through proposing the necessity of time synchronization of all nodes before data collection,the paper discusses the principle of time synchronization.At last,we built a health monitoring system which was composed by data collection,data transmission,data reception and data analysis.And we tested the system in the anchor cable of Runyang Yangtze River Bridge.We installed the wireless sensor node in the anchor cable and obtained its vibration information through accelerometer.Then these data was sent to the base station,and to monitoring center in final.By analyzing these data,the vibration frequency spectrum of anchor cables could be obtained.Through analyzing the frequency,the strength of bridge's cables would be figured out.It is useful to identify if the bridge is in a healthy status.If the data deviates from the normal range,the monitoring center will respond in time.At last,the paper gives a conclusion that the wireless system is suitable for bridge structural health monitoring field and useful for actual application.

Design of the wireless system for health monitoring of a large span gymnasium structure

Design And Testing Of A Wireless Strain Sensor Toward Large-Span Spatial Structures

Development Of A Customized Wireless Sensor System For Large-Scale Spatial Structures And Its Applications In Two Cases

Development Of A Multitype Wireless Sensor Network For The Large-Scale Structure Of The National Stadium In China

Implementation of SHM System for Hangzhou East Railway Station Using a Wireless Sensor Network

Wireless transmission for health monitoring of large structures

The design of densely measured points long-term monitoring system based on wireless sensor network

A New Type of Intelligent Wireless Sensing Network for Health Monitoring of Large-Size Structures

Health Dynamic Measurement of Tall Building Using Wireless Sensor Network

Design of wireless intelligent sensor for structural health monitoring

Research And Application Of Structure Health Monitoring System In Long-Span Spatial Structure

Design, Calibration and Application of Wireless Sensors for Structural Global and Local Monitoring of Civil Infrastructures

Wireless Sensing System for Health Monitoring of Key Structures

Distributed Strain Sensor Networks for In-Construction Monitoring and Safety Evaluation of a High-Rise Building.

A Structural Health Monitoring System Using Wireless Sensor Network

The Intelligent Method and Implementation of Health Monitoring System for Large Span Structures

Engineering Application of Wireless Safety Monitoring of Supporting Structure

Strain Sensor-Based Wireless Measurement System for Bridge

A new method for bridge structural health monitoring based on wireless sensor networks

Design and Implementation of Wireless Identification and Sensing Platform in Structure Monitoring

Wireless Inclinometer Sensor and Its Data Acquisition System for Swing Monitoring of Large Scale Structures