Abstract:For structural health monitoring of large bridges,the traditional manual detection is inadequate because of its strong subjectivity,bad entirety and bad timeliness.The widely used wired health monitoring system also has some problems in the actual applications.For example,it is hard to wire in some area and it is easy to be affected by environment.Using wireless sensor networks in bridge structural health monitoring not only retains the advantage of wired health monitoring system but also makes up for its deficiencies in the applications.The paper describes the composition of the whole system,and discusses the composition of wireless sensor nodes in the monitoring area of the system.Through studying the composition of base station,the paper gives the role of base station in the health monitoring system.On the basis of the composition of wireless sensor nodes,the paper addresses the mean value drift of the accelerometer output resulting from temperature changes.It gives a method to calibrate the output value of using temperature compensation technology.In order to verify this method,we give a comparison between uncorrected accelerometer readings and corrected accelerometer readings.Then,through proposing the necessity of time synchronization of all nodes before data collection,the paper discusses the principle of time synchronization.At last,we built a health monitoring system which was composed by data collection,data transmission,data reception and data analysis.And we tested the system in the anchor cable of Runyang Yangtze River Bridge.We installed the wireless sensor node in the anchor cable and obtained its vibration information through accelerometer.Then these data was sent to the base station,and to monitoring center in final.By analyzing these data,the vibration frequency spectrum of anchor cables could be obtained.Through analyzing the frequency,the strength of bridge's cables would be figured out.It is useful to identify if the bridge is in a healthy status.If the data deviates from the normal range,the monitoring center will respond in time.At last,the paper gives a conclusion that the wireless system is suitable for bridge structural health monitoring field and useful for actual application.

Special Collection: Towards Smart Buildings and Structures: Condition Monitoring, Assessment and Control Autonomous Main-Cable Vibration Monitoring Using Wireless Smart Sensors for Large-Scale Three-Pylon Suspension Bridges: A Case Study

Autonomous Main-Cable Vibration Monitoring Using Wireless Smart Sensors for Large-Scale Three-Pylon Suspension Bridges: A Case Study

Estimation of Main Cable Tension Force of Suspension Bridges Based on Ambient Vibration Frequency Measurements

Design and Experimental Investigations of a Vibration Based Wireless Measurement System for Bridge Cable Tension Monitoring

Long-Term In-Service Monitoring and Performance Assessment of the Main Cables of Long-Span Suspension Bridges

Study on Health Monitoring System Design of Cable-Stayed Bridge

Vibration-Based Bridge Health Monitoring using Telecommunication Cables

A new method for bridge structural health monitoring based on wireless sensor networks

Vibration-Based Damage Detection Of Cable-Stayed Bridges

Statistical Analysis of Modal Properties of a Cable-Stayed Bridge through Long-Term Wireless Structural Health Monitoring

Autonomous structural health monitoring using wireless smart sensors on a cable-stayed bridge

Large-Scale Bridge Structural Health Monitoring System Based on Smart Sensor Networks

Automated Wireless Monitoring System for Cable Tension Using Smart Sensors

Structural Health Monitoring of a Long-span Cable-stayed Bridge

Health monitoring and assessment management system of Wenhui Bridge

A wireless smart sensor network for automated monitoring of cable tension

Force Monitoring of Steel Cables Using Vision-Based Sensing Technology: Methodology and Experimental Verification

Smart wireless tension force monitoring system for stay cables

Long-Range Low-Power Multi-Hop Wireless Sensor Network for Monitoring the Vibration Response of Long-Span Bridges

Multi-channel fiber optical sensing system for urban bridge cluster health monitoring

An Introduction to the Heterogeneous SHM System for a Super-large-scale Multiple-tower Suspension Bridge