Abstract:NbMoTaW and VCrTaW high-entropy alloys (HEA) coatings with near-equal atomic ratios were deposited onto the T91 substrate by magnetron sputtering. The two HEA coatings and the T91 substrate were irradiated to the peak damage 50 displacements per atom (dpa) and 100 dpa using 2.7 MeV Si2+ at 550 °C. X-ray diffraction (XRD), Scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy dispersive X-ray spectroscopy (EDS) and nanoindentation techniques were used to study the changes in grain morphology, microstructure, element distribution and hardness before and after irradiation. The results showed that the grain structure was stable and the coatings were closely bonded to the substrate after irradiation. The elements (Ta and W) near the grain boundary in NbMoTaW coating were depleted before irradiation, but they became homogenized after irradiation. A large number of dislocation loops were observed in both the T91 substrate and HEA coatings after irradiation, the HEA coatings significantly increased the doses required for the full evolution of the dislocation loops. With the increase of damage doses, the dislocation loops size of HEA coatings increased and the number density decreased. The size of the dislocation loops of the two coatings was similar, while the number density of the dislocation loops of NbMoTaW coating was lower than that of VCrTaW coating. Both HEA coatings were significantly hardened after irradiation and the hardening rate of NbMoTaW coating was lower than that of VCrTaW coating. Interestingly, the hardening rate of 50 dpa was higher than 100 dpa for both HEA coatings, which was determined by softening factor and hardening factor in the irradiation process. Based on the defects and hardening rate caused by irradiation, it was preliminarily concluded that NbMoTaW coating had better irradiation resistance, and the above results provide an important reference for the subsequent optimization of lead-based fast reactors structural materials.

Irradiation-induced swelling and hardening in HfNbTaTiZr refractory high-entropy alloy

Irradiation-Hardening Model of TiZrHfNbMo0.1 Refractory High-Entropy Alloys

The Microstructural and Hardness Changes of Tungsten Fiber after Au2+ Irradiation

Mechanical Behavior of the HfNbZrTi High Entropy Alloy after Ion Irradiation Based on Micro-Pillar Compression Tests

Irradiation damage versus lattice distortion in AlNbTiVCrx (x = 0, 0.5, 1) high-entropy alloys from first-principles calculations and irradiation experiments

He-ion Irradiation Effects on the Microstructures and Mechanical Properties of the Ti-Zr-Hf-V-Ta Low-Activation High-Entropy Alloys

Irradiation damage in (Zr0.25Ta0.25Nb0.25Ti0.25)C high-entropy carbide ceramics

The Influence of Phase Formation on Irradiation Tolerance in a Nanocrystalline TiZrNbHfTa Refractory High‐Entropy Alloy

High radiation tolerance of an ultrastrong nanostructured NiCoCr alloy with stable dispersed nanooxides and fine grain structure

Enhanced plasticity in a Zr-rich refractory high-entropy alloy via electron irradiation

Microstructure and micromechanical responses of bulk nanostructured high entropy alloy after heavy-ion irradiation at 500°C

Irradiation damage behavior of the non-equal atomic AlNbMoZrB high-entropy alloy

A comparative study of irradiation response in amorphous TaTiWVCr refractory high entropy alloy with the counterpart of tungsten films

Simulations of irradiation resistance and mechanical properties under irradiation of high-entropy alloy NiCoCrFe

Evaluation of Radiation Response in CoCrFeCuNi High-Entropy Alloys.

Fracture Toughness Investigations of an Ion‐Irradiated Nanocrystalline TiZrNbHfTa Refractory High‐Entropy Alloy

Composition control and heat treatment effect on characteristics of ZrNbTaHf x refractory high entropy alloys

Radiation Damage of 1cr18ni9ti and Zr-Ti-Al Alloys Due to Energetic Particle Irradiation

Swift heavy ion irradiation effects in zirconium and hafnium carbides

Evolution of microstructure and mechanical properties of ZrC reinforced FeCrAl alloy after Fe-ions irradiation

Dislocation loops, segregation and hardening induced by high-dose ion irradiation of NbMoTaW and VCrTaW high-entropy alloy coatings on the T91 substrate