Abstract:The structure and stabilization mechanism of laminar nonpremixed autoignitive DME/air coflow flames was investigated at elevated temperatures and pressures. Computations with detailed chemistry were performed for DME and heated coflow air at 30 atm with uniform inlet velocities (2.4, 3.2, and 8.0 m/s) imposed for both streams. The heat release rate profiles are first examined for each case to demonstrate a multibrachial thermal structure. Species concentrations and temperature were sampled along mixture fraction iso-contours, and Chemical Explosive Mode Analysis (CEMA) was performed to identify the controlling chemistry at representative points. One-dimensional Lagrangian Flamelet Analysis (LFA) was also performed and compared with the two-dimensional computations to elucidate the relative importance of diffusion processes parallel and normal to the mixture fraction gradient. Various coflow temperatures with different inlet velocities are examined to elucidate their influences on the multibrachial structure as well as the stabilization mechanism. NTC (negative temperature coefficient)-affected inhomogeneous autoignition and the coupled effects with premixed flame propagation on stabilization are further studied. It is found that, at high coflow boundary temperatures or low inlet velocities, the classical tribrachial flame structure is achieved, and autoignition contributes less to the stabilization due to reduced heat and radical accumulation. The kinematic balance between the local flow speed and flame propagation speed is the dominant stabilization mechanism. On the contrary, kinetic stabilization is achieved at lower coflow temperatures or higher inlet velocities as autoignition becomes dominant. Due to the transition of the dominant chemical pathways during autoignition, the kinetically stabilized structure is usually multibrachial. The transition of different stabilization mechanisms can be made by changing either the boundary velocity or temperature of the coflow. Based on these results and previous work (Deng et al., 2015)[12], a regime diagram is constructed that identifies the possible stabilization regimes: blow out, kinetically stabilized, autoignition-propagation-coupled stabilized, kinematically stabilized, and burner stabilized. (C) 2015 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Effect of Thermal Condition of Solid Wall on the Stabilization of a Preheated and Holder-Stabilized Laminar Premixed Flame

Stabilization Mechanism of Burner-attached Flames in Laminar Non-premixed Jets

A Novel Flame-Anchorage Micro-Combustor: Effects of Flame Holder Shape and Height on Premixed CH4/air Flame Blow-off Limit

Flame Interaction and Stabilization Mechanisms in a Dual Premix Swirl Combustor with a Pilot Bluff Body

Effect of confinement ratio on flame structure and blow-off characteristics of swirl flames

Velocity nonuniformity and wall heat loss coupling effect on supersonic mixing layer flames

Flame Front Stability of Low Calorific Fuel Gas Combustion with Preheated Air in a Porous Burner

Analysis of Supersonic Shear Effects on Flame Characteristics of an Evaporating Flame-Holder

Flame stabilization characteristics in the supersonic combustor based on a circular cross-section strut

Influence of Preheating and Burner Geometry on Modeling the Attachment of Laminar Coflow CH4/air Diffusion Flames

Stabilization of Laminar Nonpremixed DME/air Coflow Flames at Elevated Temperatures and Pressures

Flame Stability Analysis Of Premixed Hydrogen/Air Mixtures In A Swirl Micro-Combustor

Flame–Solid Interaction: Thermomechanical Analysis for a Steady Laminar Stagnation Flow Stoichiometric NH3–H2 Flame at a Plane Wall

Flame-Solid Interaction: Thermomechanical Analysis for a Steady Laminar Stagnation Flow Stoichiometric NH3-H-2 Flame at a Plane Wall

Flow, Mixing, and Flame Stabilization in Bluff-Body Burner with Decreased Central Jet Velocity

Improvement of Micro Flame Stability by Increasing Reaction Temperature

The Impact of Preheating on Stability Limits of Premixed Hydrogen–Air Combustion in a Microcombustor

The Impinging Wall Effect on Flame Dynamics and Heat Transfer in Non-Premixed Jet Flames

High-fidelity Numerical Analysis of Non-Premixed Hydrothermal Flames: Flame Structure and Stabilization Mechanism

Effects of wall thickness and material on flame stability in a planar micro-combustor

Experimental Investigation and Numerical Analysis on Flame Stabilization of CH4/air Mixture in a Mesoscale Channel with Wall Cavities