Cross-scale Analysis of the Energy Recovery Process in Pressure Exchanger and Pipeline System

Zheng Cao,Jianqiang Deng,Fanghua Ye
DOI: https://doi.org/10.5004/dwt.2020.25201
IF: 1.1
2020-01-01
Desalination and Water Treatment
Abstract:The pressure exchanger is a key component in the seawater reverse osmosis system. This work focused on the one-dimensional and three-dimensional co-simulation between device and pipeline scale. The coupling calculation was carried out by combining the method of characteristic with computational fluid dynamics through the self-programming platform, with satisfying accuracy and computational efficiency. With the extracted modeling data, the pressure surge under transient operating conditions was evaluated. Several methods suppressed the pressure fluctuation of the pipeline under transient conditions were presented. The effects of flow arrangement and valve closure schemes on hydraulic performance were discussed based on a subsystem simulation case. The calculation results showed that the correction factor and initial pressure value are the main factors that largely affect the convergence process in the co-simulation. The calculated pressure loss in the high-pressure area and low-pressure area of the rotary pressure exchanger are about 0.13 and 0.073 MPa, respectively. As for the hydraulic transient control, valve closure time was the most obvious effect on pressure fluctuation. When operated at an optimum fast closure rate of 60%, the fast-slow valve closure scheme can be applied for reducing pressure peak to the minimum. In addition, the U flow arrangement was recommended in process design for higher energy transfer efficiency as well as lower pressure surge.
What problem does this paper attempt to address?