Abstract:Due to the lack of internal flow field information, the influence of structural parameters on fluid flow is not clear, which makes the heat transfer mechanism of the shell-tube heat exchanger shell side unclear and hinders the further standardization and generalization of its design criteria. Aiming at the above problems, geometry modeling and corresponding numerical simulations were carried out for the shell side flow of spiral wound heat exchangers. The feasibility and accuracy of these modellings were verified by comparing with experimental data in the literature. Then the flow field and characteristics of shell side fluid were investigated in detail. The heat transfer enhancement mechanism was further discussed based on the analysis of the influences of key structural parameters on the heat transfer and resistance performance. The results show that the fluid flow on the shell side can be described more accurately by using Realizable k-ε turbulence model. The Nusselt number increases linearly with the increase of the Reynolds number in a log-log coordinate system, while the friction factor f decreases linearly. The Nusselt number increases as the results of increased winding tube diameter d and average winding diameter D, and decreased pitch S. But it was opposite for the friction factor f. The heat transfer and resistance performance of the shell side are mostly affected by the winding tube diameter d, and the average winding diameter D does the least. Increased winding tube diameter d and average winding diameter D will break the boundary layer of the fluid flow. Then the fluid disturbance increases and hence the temperature increases faster. It is beneficial to enhance heat transfer on shell side. While increased pitch S will make the fluid flow much more smoothly, which causes velocity boundary layer to thicken. Thus flow resistance and temperature rising rate are reduced, it is not good for enhancement of heat transfer on shell side.

Structure Optimization and Dynamic Performance Studyof Self-driven Rotary Pressure Exchanger

Non-linear mapping and multi-objective optimization of leading flow structure in plate-fin heat exchanger

Performance Study of Supercharged Rotary Pressure Exchanger With Wave Analysis

Multi-Objective Optimization on the Structural Parameters of Spiral Wound Heat Exchanger

Structural Optimization of Shell-Tube Heat Exchanger with Helical Baffles Based on Fluid-Structure Interaction

Structural Design Analysis of Sliding Vane Pressure Exchanger

Experimental Research on Pressure Loss of Rotary Pressure Exchanger

Research on Structural Parameter Optimization and Thermal Performance of Twin-Screw Expander

Numerical study on influence of structural parameters of spiral rotor internal insert on heat transfer

Performance Simulation and Structure Optimization for Fin -tube Heat Exchanger in Air Handle Unit

Simulation Analysis of Ejector Optimization for High Mass Entrainment under the Influence of Multiple Structural Parameters

Integration of Cfd and Rtd Analysis in Flow Pattern and Mixing Behavior of Rotary Pressure Exchanger with Extended Angle

Optimization of Structural Parameters for Corrugated Plates Separator With Single Scoop

Optimization of thermal and flow characteristics of plate heat exchanger with variable structure parameter

Numerical Study on the Structural Optimization of R290 Two-Phase Ejector with a Non-Equilibrium CFD Model

Experimental Investigation on the Thermodynamic Performance of a Rotary Vane Expander in the Air System

Investigation on the Rotary Vane Expander by Introducing High Pressure into Vane Slots

Multi-objective optimization on shell-side performance of rod-baffle heat exchangers with twisted oval tubes

Study of a Rotary Vane Expander for the Transcritical CO 2 Cycle—Part II: Theoretical Modeling

Study on effects of structural parameters on shell-side heat transfer enhancement in spiral wound heat exchangers

Structural Optimization of Self-Supporting Rectangular Converging-Diverging Tube Heat Exchanger