Investigation of Mn incorporation into NiOOH electrocatalyst loaded on BiVO4 photoanode for enhanced photoelectrochemical water splitting: Experimental and theoretical approach

A. Soundarya Mary,C. Murugan,D. Mahendiran,P. Murugan,A. Pandikumar,Soundarya Mary A,Murugan C,Mahendiran D,Murugan P,Pandikumar A
DOI: https://doi.org/10.1016/j.mtener.2024.101541
IF: 9.257
2024-02-01
Materials Today Energy
Abstract:Loading of oxygen evolution reaction (OER) cocatalyst is an effective strategy to overcome the inherent poor charge separation of BiVO4. Incorporation of Mn-doped NiOOH electrocatalyst on the electrochemically deposited BiVO4 photoanode surface boosts the photoelectrocatalytic (PEC) water oxidation. Here, the Mn–NiOOH/BiVO4 (10%) photoanode exhibited ∼2.6- and ∼1.7-fold higher photocurrent density (2.41 mA/cm2) than BiVO4 and BiVO4/NiOOH, respectively. Noticeably, it delivered the transient decay time (τ) of 1.83 s, which is ∼3.5- and ∼2.3-fold higher than the BiVO4 and BiVO4/NiOOH, respectively, besides the BiVO4/Mn–NiOOH (10%) utilizes 42.4% of the photogenerated holes, whereas in BiVO4, it is only 17.06%, and BiVO4/NiOOH exhibits 25.98% for the water oxidation process. The enhanced PEC activity of the BiVO4/Mn–NiOOH photoanode is due to reduced photoinduced charge carrier's recombination rate, facile interfacial charge transfer, and rapid hole consumption. Moreover, the higher efficiency of Mn–NiOOH cocatalyst is understood by applying density functinal theory (DFT) studies and revealed that Mn–NiOOH (10%) has lower formation energy than higher concentrations and infers that it requires the lower overpotential (2.37 V) than NiOOH (3.06 V). Overall, under illumination, Mn–NiOOH consumes the photogenerated holes from BiVO4 for the cyclic catalytic process of NiOOH, thus enhancing the PEC performance.
materials science, multidisciplinary,chemistry, physical,energy & fuels
What problem does this paper attempt to address?