Abstract:Doping and surface-modification by co-catalysts are well-established strategies for the performance enhancement of bismuth vanadate (BiVO4) photoanodes for photoelectrochemical (PEC) water splitting devices. However, our knowledge of the complex effects of doping and surface modification that govern the PEC performance is still underdeveloped, which makes the rational design of high-performance BiVO4-based photoanodes challenging. Herein, a remarkably effective strategy for enhancing the performance of BiVO4 photoanodes by combining the bulk doping of BiVO4 with molybdenum (Mo) and its surface modification with a well-defined molecular cobalt polyoxometalate water oxidation catalyst (CoPOM = Na10[Co4(H2O)2(PW9O34)2]) via a simple impregnation protocol without any linkers or binders is reported. The best-performing optimized Mo-BiVO4/CoPOM photoanode exhibits a photocurrent density of 4.32 mA cm−2 at 1.23 V vs. RHE under AM 1.5G (1 sun) illumination and an applied-bias photoconversion efficiency (ABPE) of ~0.73%, which is an improvement by the factor of ~24 with respect to pristine BiVO4. The respective contributions of the Mo-doping and modification with CoPOM to the performance enhancement are disentangled based on detailed mechanistic investigations. The positive effect of Mo-doping is shown to be related to enhanced electronic conductivity and passivation of surface states, whereby these beneficial effects are operative only at relatively high applied bias potentials (> 0.9 V vs. RHE), and at lower bias potentials (< 0.7 V vs. RHE) they are counterbalanced by strongly detrimental effects related to increased concentration of electron polaronic states induced by the Mo-doping. The highly beneficial effect of CoPOM deposition is unambiguously demonstrated to be related to the enhancement of water oxidation catalysis. Notably, the molecular CoPOM acts as a pre-catalyst, as it undergoes (at least partially) conversion to cobalt oxide under the PEC operating conditions. Our work thus establishes CoPOM-derived catalysts as effective water oxidation catalysts at BiVO4 photoanodes, and suggests that further progress in BiVO4 photoanode development depends critically on devising alternative strategies for conductivity enhancement that would avoid the negative polaronic effects associated with the conventional bulk doping of BiVO4.

BiVO4 photoanode decorated with cobalt-manganese layered double hydroxides for enhanced photoelectrochemical water oxidation

Synergistic Effect of Co3(HPO4)2(OH)2 Cocatalyst and Al2O3 Passivation Layer on BiVO4 Photoanode for Enhanced Photoelectrochemical Water Oxidation

Fabrication of BiVO4-Ni/Co3O4 photoanode for enhanced photoelectrochemical water splitting

A Molecular Cobaloxime Cocatalyst and Ultrathin FeOOH Nanolayers Co-Modified BiVO 4 Photoanode for Efficient Photoelectrochemical Water Oxidation

Photoanode of LDH catalyst decorated semiconductor heterojunction of BiVO4/CdS to enhance PEC water splitting efficiency

Promoting the Photoelectrochemical Properties of BiVO4 Photoanode via Dual Modification with CdS Nanoparticles and NiFe-LDH Nanosheets

Molecular Copper Phthalocyanine and FeOOH Modified BiVO4 Photoanodes for Enhanced Photoelectrochemical Water Oxidation

Super-hydrophilic CoAl-LDH on BiVO4 for enhanced photoelectrochemical water oxidation activity

Charge Transport Enhancement in BiVO4 Photoanode for Efficient Solar Water Oxidation

Boosting the Photoactivity of BiVO4 Photoanodes by a ZnCoFe-LDH Thin Layer for Water Oxidation

High-Performance BiVO4 Photoanodes: Elucidating the Combined Effects of Mo-Doping and Surface-Modification with Polyoxometalate Co-Catalysts

Ni-Doped BiVO4 photoanode for efficient photoelectrochemical water splitting

Ni3B modified BiVO4 photoanodes for enhanced photoelectrochemical water splitting: The key role of Ni3B on reducing the water oxidation barrier

Green light all the way: Triple modification synergistic modification effect to enhance the photoelectrochemical water oxidation performance of BiVO4 photoanode

Enhanced bulk and interfacial charge transfer in Fe:VOPO4 modified Mo:BiVO4 photoanodes for photoelectrochemical water splitting

Coupling surface modification with cocatalyst deposition on BiVO4 photoanode to enhance charge transfer for efficient solar-driven water splitting

Integration of surficial oxygen vacancies and interfacial two-dimensional NiFe-layered double hydroxide nanosheets onto bismuth vanadate photoanode for boosted photoelectrochemical water splitting

New BiVO4 Dual Photoanodes with Enriched Oxygen Vacancies for Efficient Solar-Driven Water Splitting

Doping with Rare Earth Elements and Loading Cocatalysts to Improve the Solar Water Splitting Performance of BiVO4

Oxygen Vacancies Enhanced WO 3 /BiVO 4 Photoanodes Modified by Cobalt Phosphate for Efficient Photoelectrochemical Water Splitting

MgO passivation layer and hydrotalcite derived spinel Co2AlO4 synergically promote photoelectrochemical water oxidation conducted by BiVO4-based photoanode