Abstract:Braiding is an attractive manufacturing method for tubular elements such as hollow shafts and struts. One of the main challenges however is the integration of suitably performing end-fittings. Recent advances in additive layer manufacture have enabled the fabrication of end-fittings which can be ‘co-impregnated’ or ‘co-cured’ with the fibre preform in a single step, i.e. without the need for secondary adhesive bonding. This requires the introduction of protrusions onto the surface of the end-fitting to promote mechanical interlocking with the fibres. However, the lack of accurate modelling tools for the simulation of this manufacturing process means that much empiricism is currently used in the design of such structures. A novel numerical framework is presented here for the full-scale simulation of the braiding process over structured end-fittings. Nonlinear finite element analysis is applied at the meso-scale, with strands of beam elements representing individual yarns and meshed surfaces modelling the mandrel and tooling. Penalty-based contact formulations are then used to simulate all inter-yarn and yarn-metal interactions, enabling detailed predictions of fibre paths around surface protrusions. In order to verify and validate this numerical framework, a series of full-scale braiding experiments was conducted using additively-manufactured thermoplastic mandrels. Final braid patterns as well as the occurrence of braid imperfections were investigated and compared to model predictions. It is shown that the proposed modelling strategy reproduces well the trends observed experimentally in terms of final braid quality. A parametric study was then conducted on the effects of initial end-fitting alignment with respect to oncoming yarns, suggesting that better control over this parameter could reduce considerably the occurrence of braid imperfections.

An Exploration of the Deformability Behaviours Dominated by Braiding Angle During the Forming of the Triaxial Carbon Fibre Braids

Shear deformation characteristics under tensile stress during forming of tubular braided fabrics

Effects of yarn interlacement in diamond triaxial braid on its patterns and tensile properties

An Analytical Model for Predicting the Elastic Properties of Triaxially Braided Composites

Influence of process induced defects for biaxial carbon fiber braids

Improved hyperelastic model for simulating the forming of biaxial braided fabrics

Experimental characterization and numerical analysis of 3D woven preforms torsional deformation

Experimental and numerical studies on the braiding of carbon fibres over structured end-fittings for the design and manufacture of high performance hybrid shafts

Theoretical Modeling on the Deformation Behavior of Auxetic Tubular Braid Made from Modified Circular Braiding Technique

Exploring deformability in 3D tufted composite reinforcements: Understanding bending behaviors in forming applications

Non-Axisymmetric Overbraiding Process Modeling Based on Enhanced Kinematic Models

STUDY ON THE ELASTIC PROPERTIES OF TRIAXIALLY BRAIDED COMPOSITES

Unit-cell geometry and mechanical properties of three-dimensional seven-directional braided composites

A deformation model and draping behavior analysis of plain weave fabric with low-twist yarn on continuous surface

Mechanical modeling of an auxetic tubular braided structure: Experimental and numerical analyses

Spatial distribution of yarns and mechanical properties in 3D braided tubular composites

Numerical investigation of tensile behavior of three-dimensional six-directional braided composites

Development of a generalized analytical model for tubular braided-architecture composites

A novel modeling method for the mechanical behavior of 3D woven fabrics considering yarn distortion

Influence of in-plane bending behaviour on textile composite reinforcement forming