Abstract:Plug flow attracts continuous interest due to its advantages of low particle attrition, low pipeline wear and low energy consumption. A novel non-mechanical draft tube type feeder (DTF) has been proposed in our previous work for vertical plug conveying of coarse particles. Detailed particle motion behaviors and plug formation mechanisms in the draft tube type feeder are investigated by the combined approach of Computational Fluid Dynamics and Discrete Element Method (CFD-DEM) in the present study. The CFD-DEM method based on local averaging of granular matter is used to deal with fluid cell sizes smaller than particle sizes under the specific conditions. The applicability of the model is verified by comparing the calculated results with the experimental results of vertical plug formation of 6mm glass beads in a draft tube type feeder, in terms of plug flow pattern, pressure drop and solid mass flow rate. Detailed analysis of the particle entrainment in feeder container, flow properties at riser inlet and natural plug formation in riser are then carried out. It is found that both gas and particle flows result in entrainment effect on particles, respectively, through fluid-particle and particle-particle interactions. The linear increase of solid mass flow rate with superficial gas velocity is closely related to the linear increase of particle vertical velocity at riser inlet. Plug formation is achieved in a natural way, which shows the features of self-organization phenomenon. Particle concentration is a key parameter in this self-organization process. This study provides some insights into the natural plug formation of coarse particles in a non-mechanical feeder. The model should be useful to study the gas-solid flow of coarse particles in a confined domain with complex geometry, where the fluid cell size may be smaller than the particle size.

Flow Mechanisms and Solid Flow Rate Prediction of Powders Discharged from Hoppers with an Insert

Study on Fine Powder Discharged from Hoppers Modified with Insert

Hopper discharge of elongated particles of varying aspect ratio: Experiments and DEM simulations

Multi-Scale Study of Particle Flow in Silos

Experimental and Cpfd Numerical Study on Hopper Discharge

Powder Discharge from a Hopper-Standpipe System Modelled with CPFD

Prediction of Solid Discharge Rates of Pulverized Coal from an Aerated Hopper

Application of CPFD in hopper discharge of fine granular material

Improving Particle Flow in Liquid-Solid Countercurrent Extraction Tower by Insert Structure Optimization: A Combined Study on Experiments and DEM Simulations

Residual Mass Prediction of Powder Discharged from Hopper at Non-Gravity Directions

Bimodal Frequency Distribution of Granular Discharge in 2D Hoppers

Study on the Flow Characteristics of Mixed Solid–Solid Particles

Numerical study of granular discharge flows through centred and off-centred rectangular hoppers using discrete element simulations

DEM Study on the Effects of Pellet Characteristics on Particle Flow in Rectangular Hopper

Study on the flow of fine powders from hoppers connected to a moving-bed standpipe with negative pressure gradient

Research on the effect of the cone-in-cone insert on the discharge behaviour of conical silo

Discharge Characteristics of Binary Particles in a Rectangular Hopper with Inclined Bottom

Investigation on Vertical Plug Formation of Coarse Particles in a Non-Mechanical Feeder by CFD-DEM Coupling Method

Study on the Fluidization and Discharge Characteristics of Cohesive Coals from an Aerated Hopper

Effect of Sudden Increase of Solid Feed Rate on the Arching in Hoppers Connected to A Moving-Bed Standpipe with Interstitial Gas Flow

Global self$-$similarity of dense granular flow in hopper: the role of hopper width