30 GHz Surface Acoustic Wave Transducers with Extremely High Mass Sensitivity

Jiangpo Zheng,Jian Zhou,Pei Zeng,Yi Liu,Yiping Shen,Wenze Yao,Zhe Chen,Jianhui Wu,Shuo Xiong,Yiqin Chen,Xianglong Shi,Jie Liu,Yongqing Fu,Huigao Duan
DOI: https://doi.org/10.1063/1.5142673
IF: 4
2020-01-01
Applied Physics Letters
Abstract:A nano-patterning process is reported in this work, which can achieve surface acoustic wave (SAW) devices with an extremely high frequency and a super-high mass sensitivity. An integrated lift-off process with ion beam milling is used to minimize the short-circuiting problem and improve the quality of nanoscale interdigital transducers (IDTs). A specifically designed proximity-effect-correction algorithm is applied to mitigate the proximity effect occurring in the electron-beam lithography process. The IDTs with a period of 160 nm and a finger width of 35 nm are achieved, enabling a frequency of ∼30 GHz on lithium niobate based SAW devices. Both centrosymmetric type and axisymmetric type IDT structures are fabricated, and the results show that the centrosymmetric type tends to excite lower-order Rayleigh waves and the axisymmetric type tends to excite higher-order wave modes. A mass sensitivity of ∼388.2 MHz × mm2/μg is demonstrated, which is ∼109 times larger than that of a conventional quartz crystal balance and ∼50 times higher than a conventional SAW device with a wavelength of 4 μm.
What problem does this paper attempt to address?