Abstract:The opposed wall-fired boiler is widely used in Chinese power plants due to its adaptability. However, deviations from design conditions can cause the reduction of combustion efficiency and combustion stability, and the overheating of heating surfaces. This study conducted numerical simulations on a 600 MW supercritical opposed wall-fired boiler at 75%, 50%, and 30% Turbine Heat Acceptance (THA) load conditions. The variation of temperature field and heat flux in the furnace under different loads, and parameters such as distributions of heat flux, temperature, and the stress of the high-temperature heating surface are analyzed. Results indicate that reducing the load from 75% to 30% THA lowers the furnace outlet temperature from 1158 to 1009 K and reduces the average gas temperature of the high-temperature heating surface from 1800 to 1570 K. Under a high load, the maximum heat flux concentrates on the side water-cooled wall of the combustion zone. However, when the load decreases, the heat absorption shifts towards the main combustion zone. Furthermore, under a high load, the average wall temperature of the high-temperature heating surface remains at 1600 K with a uniform temperature distribution. In contrast, when the load drops to 30% THA, significant temperature differences appear on the heating surface, with a maximum difference of 400 K. This leads to excessive expansion and slagging on the high-temperature heating surface, particularly in the middle and lower sections, due to the increased stress. These findings offer valuable insights for optimizing the combustion characteristics of opposed wall-fired boilers and preventing overtemperature explosions on the platen heating surface.

Identification of the running status of membrane walls in an opposed fired model boiler under varying heating loads

Experimental Study on Temperature, Heat Flux, Strain and Stress Distribution of Boiler Water Walls

Experimental study on heat transfer process in boilers to predict thermal strain/stress distribution and deformation risk of membrane walls

Experimental Study on the Distribution of Temperature and Deformation in the Water Walls of an Opposed Firing Boiler under Variable Load Conditions

Experimental Study on the Working States of Membrane Walls in the Arch-Fired Boiler with Different Fuel Proportion Coefficients

Experimental Study and Simulation Analysis of Heat and Deformation in the Water Walls of an Opposed Firing Boiler under Flexible Operating Conditions

Three-Dimensional Thermal Stress Distribution of Opposed Firing Boiler: Numerical Study and Experimental Verification

Numerical Study of Supercritical Opposed Wall-Fired Boiler Furnace Temperature and High-Temperature Heating Surface Stress under Variable Load Operation

The Working Status and Deformation Risk of Membrane Walls Affected by the Arrangement of Burners in the Arch-Fired Boiler

Dynamic Analysis for Ultra-Supercritical Boiler Water Wall Considering Uneven Heat Flux Distribution and Combustion Instability

Thermal Stress and Strain Distributions of a Laboratory Scale Wall Fired Furnace: A Numerical Study and Experimental Verification

Experimental Study on the Influence of the Temperature and Thermal Stress of Water Wall in Different Arrangements of Burners

Numerical Calculation on Temperature Fields of Vertical Waterwall in Ultra-supercritical Boilers

Investigation on Hydrodynamic Performance and Wall Temperature of Water-Cooled Wall in 1000 MW Boiler Under Low-Load Conditions

Experimental Study of Deformation Risk and Interpolation Analysis of Temperature for Water Walls under Flexible Low-Load Conditions

Numerical Simulation Of Heat Load Distribution In A 1100t/H Boiler

Experimental Investigation and Model Validation of the Heat Flux Profile in a 300 MW CFB Boiler

Steam Temperature Characteristics in Boiler Water Wall Tubes Based on Furnace CFD and Hydrodynamic Coupling Model

Analysis and Prediction of Thermal Stress Distribution on the Membrane Wall in the Arch-Fired Boiler Based on Machine Learning Technology

Study on Thermal Sensitivity Characteristics of Vertical Membrane Water Wall in Supercritical Pressure W Shaped Flame Boiler

Effect of Circumferential Flow Non-uniformity on the Temperature Distribution of Membrane Water Wall in Supercritical Boilers and Simplified Calculation Methods