Discrete element modeling of particle flow behaviors in a gas-solid bubbling fluidized bed using dynamic restitution coefficient
Guodong LIU,YU Fan,LU Huilin,Shuai WANG,Liyan SUN,Yanan ZHANG
2015-01-01
Abstract:The Discrete Element Model (DEM) is a very promising modelling strategy for particle-fluid two-phase systems. In this study, a small two dimensional gas-solid bubbling fluidized bed was simulated using DEM. A dynamic restitution coefficient for particle collisions was employed to simulate the wet particle flow behaviours by taking the energy dissipation of colliding particles into account. The influences of restitution coefficient, superficial velocity on the distribution of particle velocity, solid fraction as well as granular temperature distribution were investigated. It was found that the dynamic restitution coefficient could be well capable of predicting the collision process of wet particles. The time-averaged velocity of particles at low superficial velocity differs considerably between “dry” and “wet” particles, however, the difference decays with the increase of superficial velocity when energy dissipation for wet particles plays a less important role. Predicted granular temperature also follows a similar trend. NOMENCLATURE p pressure m mass u velocity g gravity F force I moment of inertia T torque r radius Cd0 drag force coefficient for single particle density dynamic viscosity ε volume fraction τ viscous stress tensor βint momentum exchange coefficient ω angular velocity of particle δ film thickness subscript p particle f fluid INTRODUCTION Gas-solid fluidized beds have been widely applied to petroleum, chemical and energy industries, which involve highly complex gas-solid two phase flows. In the gasfluidized bed, the fluidization is aggregative, where the gas phase will aggregate when the particle passes by, forming bubbles in the bed. Fluidization of dry particles could be well predicted by the continuous fluid model. However, the existence of liquid film gives rise to the increase of dissipative energy of solids. The energy dissipation of solid particles can change the interacting mechanism among colliding particles, thus it has an influence on the fluidization behaviour of particles, such as agglomeration and channel flow. This phenomenon could hazard some industrial applications. In present work, we have used the DEM-CFD method, combining with the collision model for particles imposed by the interstitial fluid. A 2D bubbling fluidized bed experimentally investigated by Holland et al. (2008) was simulated. We simulated the fluidization of dry and wet particles with different superficial gas phase velocities, and the effect of the wet particle fluidization characteristics was obtained by comparing the distribution of particle velocity, solid fraction as well as granular temperature. MODEL DESCRIPTION The Discrete Element Method (DEM) (Cundall and Strack, 1979) treats the gas phase as continuum and solid phase as dispersed particles. The motion of solid particles follows Newton’s second law. This method can trace the position and velocity of each individual particle by solving its own mass and momentum conservation equations. The typical forces considered are gravity and contact forces due to particle collisions. The open source software of MFIXDEM was used in the simulation. Equation for continuum phase The fluid is the continuous phase, which follows the mass and momentum equations of conservation. Continuum equation ( ) ( ) 0 f f f f ρ ε ρ ε t f u (1) Momentum equation ( ) ( ) f f f f f f f f f ρ ε ρ ε ε p ε t ε ρ f f f