Abstract:Due to their high thermal efficiency, good reliability and durability, low fuel consumption, and low carbon dioxide emission, diesel engines are widely used in both stationary and mobile applications. However, the inherent combustion mode of diesel engines results in high particulate matter (PM) emissions. In order to meet the increasingly stringent PM emission standard, the diesel particulate filter (DPF) has become a necessary configuration to remove PM for diesel engines. Increasing damage of fuel consumption with DPF soot loading leads to the requirement of regeneration process. DPF active regeneration is a process from hydrocarbon (HC) oxidation in diesel oxidation catalyst (DOC) to deposited particle oxidation in DPF, involving the whole aftertreatment system. First, previous studies mainly focused on single converter, and have rarely explored the regeneration process considering the whole aftertreatment system. Second, few studies have conducted in-depth introductions to the microscopic oxidation characteristics of deposited particles during regeneration. Third, the high temperature resulted from the active regeneration has an important impact on the performance of selective catalytic reduction (SCR), which may be a problem to be considered in the next emission regulations, but few studies have reported this aspect. This study focuses on full course evolution process under DPF active regeneration considering the whole aftertreatment system. Taking the HC concentration as the research variables, the HC slip phenomenon, the microscopic oxidation characteristics of deposited particles, the temperature field characteristics, and the influence of active regeneration on SCR performance are systematically investigated. This study can provide valuable guidance for further understanding of DPF active regeneration characteristics, regeneration control strategy formulation and DPF durability improvement.

The Research on Comprehensive Performance of HC Injection System Used in DPF Regeneration Process

Study on injection characteristics of diesel and DME

An Experimental Study about the Characteristics of Reciprocating Flow Regeneration of Diesel Particulate Filter with Diesel Vapor Injection

Simulation of Hydrocarbon Injection used for Catalyzed Diesel Particulate Filter during Active Regeneration Process

Study on Secondary Pollution of DPF Regeneration Assisted with DOC

Full course evolution characteristics of DPF active regeneration under different inlet HC concentrations

The Application of Two Closely Coupled DPFs as the After-treatment System

Experimental Investigation of Homogeneous Charge Induced Ignition (hcii) with Low-Pressure Injection to Reduce Pm Emissions in A Heavy-Duty Engine

Experimental Study on a Diesel Particulate Filter with Reciprocating Flow.

Study on Burner Type Diesel Particulate Filter System Using Compressed Air from Turbocharger

Analysis of Mechanism of Ducted Fuel Injection under Non-Vaporizing Condition

Experimental Study on the Diesel Injection Pressure of Homogeneous Charge Induced Ignition for Multi-cylinder Operation

Simulation of Low Temperature Combustion Mechanism of Different Combustion-Supporting Agents in Close-Coupled DOC and DPF System.

Investigations on the Temperature Distribution of the Diesel Particulate Filter in the Thermal Regeneration Process and Its Field Synergy Analysis

Research and development of an advanced combustion system for the direct injection diesel engine

Hybrid Modeling and Simulation of Multidimensional Processes for Diesel Particulate Filter During Loading and Regeneration

An Experimental Study on Combustion and Particulate Emissions Characteristics on a Dual-Injection Gasoline Engine

Performance and Emissions of Gasoline Homogeneous Charge Induced Ignition (HCII) by Diesel Through Whole Operating Range on a Heavy-Duty Multi-Cylinder Engine

DOC Assisted DPF Regeneration under Idle Condition

Research on the Working Performance of Carbonized Micro-wood Fiber DPF

Experimental investigation on the combustion and emissions in a pilot ignited direct injection natural gas engine using HCDI strategy