Abstract:Duplex stainless steels (DSS), characterized by a two-phase microstructure of ferrite (alpha) and austenite (gamma), have an attractive combination of mechanical strength and corrosion resistance in various aggressive environment. DSS SAF2304 shows wide application potential due to its lower cost compared with conventional DSS and better corrosion performance than austenite steel. However, precipitations of detrimental phases inevitably occur when DSS is heated to temperatures ranging from 300 degrees C to 1000 degrees C during manufacturing and welding procedures. These precipitations will lead to the reduction of corrosion resistance of DSS due to the presence of chromium-depleted zones around them. This work investigates the influence of sensitive temperature on the localized corrosion resistance of DSS SAF2304. The resistances to intergranular corrosion and pitting corrosion of DSS SAF2304 annealed at various temperatures ranging from 600 degrees C to 950 degrees C for 2 h were investigated by means of double loop electrochemical potentiodynamic reactivation (DL-EPR) technique in a solution of 1 mol/L H2SO4+1 mol/L HCl+0.2 mol/L NaCl at 30 degrees C with a scanning rate of 1.667 mV/s and critical pitting corrosion temperature (CPT) technique in a solution of 1 mol/L NaCl with a rising rate of 1 degrees C/min; respectively. The morphologies and microstructures of the specimens after electrolytic etching in 30%KOH, oxalic acid and potassium metabisulfite were characterized by OM and SEM techniques. A same trend was observed by the different evaluating techniques, which suggested that both of the resistances of intergranular corrosion and pitting corrosion of DSS SAF2304 decreased with the annealing temperature increased from 600 degrees C to 700 degrees C, while a contrary trend was found from 750 degrees C to 950 degrees C. In particular, the samples annealed at 700 and 750 degrees C suffered the severest corrosion. The relationship between microstructure and localized corrosion resistance was revealed by the evolution of the microstructure; and it was found that the deterioration of the resistance to localized corrosion was due to the formation of chromium depleted zones around the precipitation of Cr2N.

Electrochemical Studies on Local Corrosion Behavior Mechanism of Super Ferrite Stainless Steel in Low-temperature Geothermal Water Environment

Revealing the Effect of O2, SO2 and H2O in Supercritical CO2 on the Corrosion Behavior of 316L Steel at Elevated Temperature

CORROSION BEHAVIOR OF SUPER-AUSTENITIC STAINLESS STEEL AL-6XN IN SUPERCRITICAL WATER

Scaling and electrochemical corrosion behavior of 304 stainless steel pipes in a simulated geothermal water environment

Scaling and Corrosion of 304 Stainless Steel and Galvanized Steel Pipes in a Simulated Geothermal Water Environment

Experiment of stainless steel corrosion and scaling in geothermal water supply pipeline

Study on High Temperature Corrosion Resistance of Domestic Super 304H Heat Resistant Steel in Real Furnace

Corrosion Behavior of Alumina-Forming and Oxide Dispersion Strengthened Austenitic 316 Stainless Steel in Supercritical Water

A Research on the Corrosion and Stress Corrosion Cracking Susceptibility of 316L Stainless Steel Exposed to Supercritical Water

Corrosion Resistance of Candidate Cladding Materials for Supercritical Water Reactor

The Influence of Sensitive Temperature on the Localized Corrosion Resistance of Duplex Stainless Steel Saf2304

Comparison and mechanism research of corrosion behavior of materials used in supercritical water-cooled reactors

High Temperature Corrosion Resistance of Different Commercial Alloys Under Various Corrosive Environments

Investigation of Thermal Corrosion Resistance for New-Type Austenitic Stainless Steel Welded Joints

A High-Resolution Study of the Different Surface State Effects on the Corrosion Behaviors of a Ferritic Steel and an Austenitic Steel in Supercritical Water

Experimental Study on the Erosion–Corrosion Characteristics of Desulfurization Slurry on Stainless Steel Pipe Materials

Corrosion Characteristics and Mechanisms of Typical Iron/nickel-Based Alloys in Reductive Supercritical Water Environments Containing Sulfides

Effect of Tempered Martensite and Ferrite/Bainite on Corrosion Behavior of Low Alloy Steel Used for Flexible Pipe Exposed to High-Temperature Brine Environment

Intergranular corrosion susceptibility of a novel Super304H stainless steel

Research Progress on Intergranular Corrosion Resistance of Super304H Austenite Stainless Steel

Galvanic corrosion behaviors of the low-carbon ferritic stainless steel ERW (electrical resistance welding) joint in the simulated seawater