Experimental Investigation of Shear Performance of Existing PC Hollow Slab

Jin Di,Yifei Sun,Kun Yu,Lei Liu,Fengjiang Qin

DOI: https://doi.org/10.1016/j.engstruct.2020.110451

IF: 5.582

2020-01-01

Engineering Structures

Abstract:Prestressed concrete (PC) hollow slab is widely used in the construction of short and medium span highway bridges in China. With the increase in the highway load, the shear capacity of hollow slab bridges constructed before the 1990s can no longer meet the requirements of new safety regulations. Further research on the shear capacity of PC hollow slabs is necessary to ensure their safety, as these bridges continue to be operational. In this study, twelve hollow slabs with spans of 20 m, 16 m, and 10 m were tested to determine the shear performance of existing PC hollow slabs. Some hollow slabs were reinforced with a 15-cm thick concrete layer on the top surface to determine its effect on the shear capacity. The load-displacement curve, web strain, cracking and ultimate loads, and cracking and failure mode of the hollow slab were experimentally determined. The finite element method was used to simulate the shear process. The results show that the 10-m hollow slabs exhibited bending-shear failure, the 16-m hollow slabs exhibited shear compression failure, and the 20-m hollow slabs exhibited diagonal compression failure. Abdominal shear oblique cracks occurred on the webs of the hollow slabs with spans of 16 m and 20 m, whereas bending shear oblique cracks were formed in the 10-m hollow slabs. With post-casting of the 15-cm thick concrete layer, the cracking loads of the hollow slabs with spans of 10 m, 16 m, and 20 m increased by 47%, 32%, and 8%, whereas the ultimate loads increased by 41%, 22%, and 18%, respectively. A comparison of the results calculated based on design specifications and the test results shows that the design provisions for specifications related to the shear capacity are highly conservative. Finally, the conventional formula for the shear capacity was modified, and new formulas were proposed based on the test results and numerical simulation results to predict the shear capacities of the 10-m and 16-m/20-m PC hollow slabs. For these hollow slabs, the mean ratios of the calculated value to the experimental/simulated value obtained using the proposed formulas are 0.993 and 0.956, and the variances are 0.005 and 0.013, respectively.