Extrapolation and inversion of near-field propeller noise measurements

Yan Wu,Michael J. Kingan,Ryan S. McKay,Sung Tyaek Go,Young-min Shim

DOI: https://doi.org/10.1016/j.apacoust.2021.108395

IF: 3.614

2022-01-01

Applied Acoustics

Abstract:This paper describes an experimental method for making high resolution measurements of the tonal noise from a UAV propeller in the acoustic near-field and then methods of using this data to predict blade loading, via inversion, and the radiated 'steady loading' and 'thickness' tones, via extrapolation. The experimental method uses a traversing probe microphone to measure the acoustic pressure along an axial line outboard of the propeller tip. The acoustic pressures were then ensemble averaged over many propeller revolutions. Because of the azimuthal periodicity of the ensemble-average pressure field produced by the propeller, the measured data was used to infer the pressure on a cylinder enclosing the propeller. These measurements are compared with a noise prediction made using data from a computational fluid dynamics simulation of the same propeller and are found to be in reasonable agreement – with differences attributed to the small differences in the predicted and actual blade loading distributions. Because of the high amplitude and evanescent nature of the near-field pressure produced by a propeller, measurements were made in a non-anechoic environment and were relatively unaffected by background noise or reverberation effects. The near-field acoustic data was used as input to an inverse problem to estimate the aerodynamic loading distribution on the propeller blades. The method was applied first to the numerical data for validation and then to the experimental data as a demonstration. The reconstructed loading distributions were then used as input to a method for calculating the radiated acoustic field and the predictions show good agreement with a direct projection using the measured near-field experimental data.

acoustics