Abstract:We report on the enhancement of turbulent convective heat transport due to vapour-bubble nucleation at the bottom plate of a cylindrical Rayleigh–Bénard sample (aspect ratio 1.00, diameter 8.8 cm) filled with liquid. Microcavities acted as nucleation sites, allowing for well-controlled bubble nucleation. Only the central part of the bottom plate with a triangular array of microcavities (etched over an area with diameter of 2.5 cm) was heated. We studied the influence of the cavity density and of the superheat $T_{b}-T_{on}$ ( $T_{b}$ is the bottom-plate temperature and $T_{on}$ is the value of $T_{b}$ below which no nucleation occurred). The effective thermal conductivity, as expressed by the Nusselt number $\mathit{Nu}$ , was measured as a function of the superheat by varying $T_{b}$ and keeping a fixed difference $T_{b}-T_{t}\simeq 16$ K ( $T_{t}$ is the top-plate temperature). Initially $T_{b}$ was much larger than $T_{on}$ (large superheat), and the cavities vigorously nucleated vapour bubbles, resulting in two-phase flow. Reducing $T_{b}$ in steps until it was below $T_{on}$ resulted in cavity deactivation, i.e. in one-phase flow. Once all cavities were inactive, $T_{b}$ was increased again, but they did not reactivate. This led to one-phase flow for positive superheat. The heat transport of both one- and two-phase flow under nominally the same thermal forcing and degree of superheat was measured. The Nusselt number of the two-phase flow was enhanced relative to the one-phase system by an amount that increased with increasing $T_{b}$ . Varying the cavity density (69, 32, 3.2, 1.2 and $0.3~\text{mm}^{-2}$ ) had only a small effect on the global $\mathit{Nu}$ enhancement; it was found that $\mathit{Nu}$ per active site decreased as the cavity density increased. The heat-flux enhancement of an isolated nucleating site was found to be limited by the rate at which the cavity could generate bubbles. Local bulk temperatures of one- and two-phase flows were measured at two positions along the vertical centreline. Bubbles increased the liquid temperature (compared to one-phase flow) as they rose. The increase was correlated with the heat-flux enhancement. The temperature fluctuations, as well as local thermal gradients, were reduced (relative to one-phase flow) by the vapour bubbles. Blocking the large-scale circulation around the nucleating area, as well as increasing the effective buoyancy of the two-phase flow by thermally isolating the liquid column above the heated area, increased the heat-flux enhancement.

Experimental study of the heat transfer properties of self-sustained biphasic thermally driven turbulence

Flow Reversal and Multiple States in Turbulent Rayleigh–Bénard Convection with Partially Isothermal Plates

Self-sustained Biphasic Catalytic Particle Turbulence

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Vibration-induced Boundary-Layer Destabilization Achieves Massive Heat-Transport Enhancement.

Heat transport in boiling turbulent Rayleigh-Bénard convection

Enhanced Heat Transport in Partitioned Thermal Convection

Thermal Waves and Heat Transfer Efficiency Enhancement in Harmonically Modulated Turbulent Thermal Convection

Cascades Of Velocity And Temperature Fluctuations In Buoyancy-Driven Thermal Turbulence

Enhancing the Critical Heat Flux Using Microchanneled Surfaces

Shear-induced modulation on thermal convection over rough plates

Flow Dynamics and Heat Transport in Turbulent Thermal Convection

Centrifugal-Force-Induced Flow Bifurcations in Turbulent Thermal Convection

Enhanced Heat Transfer and Symmetry Breaking in Three-Dimensional Electro-Thermo-hydrodynamic Convection

Experimental and numerical study of structural parameters on the heat transfer performance of submerged cooling system

Temperature fluctuations and heat transport in partitioned supergravitational thermal turbulence

Experimental Study on The Instability and Transition of the Natural Convection Boundary Layer

Heat-flux Enhancement by Vapour-Bubble Nucleation in Rayleigh–Bénard Turbulence

Experimental Study on the Heat Transfer Performance of Pump-assisted Capillary Phase-change Loop

Boiling after Immersion of a Superheated Object in a Quasi-Adiabatic System and the Bulk Effect of Heat Transfer

Experimental Techniques for Turbulent Taylor–Couette Flow and Rayleigh–Bénard Convection