Abstract:It was recently discovered that a partitioned Rayleigh-Benard convection (PRBC) by vertical adiabatic boards leaving a narrow horizontal channel (HC) open between partition boards and the cooling/heating plates, may remarkably enhance the overall heat transfer (Bao et al., 2015). This phenomenon is thoroughly investigated by both numerical and analytic study. Numerically, we perform a series of two-dimensional (2-D) direct numerical simulations (DNS) of PRBC for the same set of Rayleigh and Prandtl numbers (Ra = 1 x 10(8), Pr = 0.7 and 5.3) and two aspect ratios (Gamma = 1 and 5). The DNS confirm that when the number of partition boards n is large enough, the flow in PRBC becomes coherent and laminar, and the wall jet in HC forms a thinner thermal boundary layer and hence enhances the heat flux from/to conducting plates. A thermosiphoning mode (TS -mode) is used to characterize this laminar forced convection state, which yields an analytic description of the relation between geometrical parameters and the heat transfer coefficient, including two asymptotes for small and large board-to-plate spacing d, where the Nusselt number (Nu) varies with d as d(3) and d(-1), respectively. The analytical model then predicts an optimal partition spacing maximizing the heat transport, in good agreement with the DNS. More interestingly, the model yields an optimal width of the vertical channel (VC) between two partition boards, in the range 0.01 <= s/H <= 1.00 for Gamma = 1, as also validated by DNS. For large VC width, we develop a convection -adaptive (CA) model describing the interplay between turbulent bulk flow in VC and the TS mode, which yields a prediction of Nu in close agreement with DNS for a wide range of n (n = 0-35 for Gamma = 5). Therefore, we have developed an analytic understanding of the PRBC enhanced heat transfer, which provides useful relations for engineering design in industrial applications. (C) 2017 Elsevier Ltd. All rights reserved.

Enhanced Heat Transport in Partitioned Thermal Convection

Flow Reversal and Multiple States in Turbulent Rayleigh–Bénard Convection with Partially Isothermal Plates

Theoretical and Numerical Study of Enhanced Heat Transfer in Partitioned Thermal Convection

Effect of partitions on flow mechanism and heat transfer in thermal convection

Experimental study of heat transfer in a rectangular cell with built-in lattice channels

Wall-sheared thermal convection: heat transfer enhancement and turbulence relaminarization

Temperature fluctuations and heat transport in partitioned supergravitational thermal turbulence

Conjugate fluid, heat and species transports inside an enclosure containing miscellaneous solid arrays: General models of electronic cooling and pollutant removals

Side-heated Rayleigh-Bénard Convection

Heat transfer enhancement in vertical convection under spatially harmonic temperature modulation

A novel concept for convective heat transfer enhancement

Experimental and numerical study of structural parameters on the heat transfer performance of submerged cooling system

Mixed convective heat transfer characteristics and mechanisms in structured packed beds

Enhanced heat transport in thermal convection with suspensions of rod-like expandable particles

Shear-induced modulation on thermal convection over rough plates

Convective Cloak in Hele-Shaw Cells with Bilayer Structures: Hiding Objects from Heat and Fluid Motion Simultaneously

Experimental and Numerical Investigation on Interfacial Mass Transfer Mechanism for Rayleigh Convection in Hele-Shaw Cell

Enhancing heat transport in multiphase Rayleigh–Bénard turbulence by changing the plate–liquid contact angles

Convective meta-thermal dispersion for self-adaptive cooling enhancement

Local thermal resistance delamination method for precise analysis and optimization of heat transfer processes

Heat transport in boiling turbulent Rayleigh-Bénard convection