Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Experimental and Numerical Investigation on Interfacial Mass Transfer Mechanism for Rayleigh Convection in Hele-Shaw Cell

A Novel Investigation of a Micropolar Fluid Characterized by Nonlinear Constitutive Diffusion Model in Boundary Layer Flow and Heat Transfer.

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Numerical Investigation on Marangoni Convection of Binary Fluids in a Closed Microcavity

Phase-field simulations for dripping-to-jetting transitions: Effects of low interfacial tension and bulk diffusion

Numerical Investigation of Near-Critical Fluid Convective Flow Mixing in Microchannels

Modeling and investigation of fluid flow affecting thermal boundary conductance at the solid-fluid interface

Interfacial Wave Behavior and Its Effect on the Flow and Condensation Heat Transfer in a Microtube

Numerical Model Development for Critical Region Flow and Thermodynamic Transitions of CO2 Fluids in Microchannel

Research on the Interfacial Instability of Non-Newtonian Fluid Displacement Using Flow Geometry

Experimental study of heat transfer in a rectangular cell with built-in lattice channels

Computational Analysis of Interfacial Dynamics in Angled Hele-Shaw Cells: Instability Regimes

A study of how solid–liquid interactions affect flow resistance and heat transfer at different temperatures based on molecular dynamics simulations

EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER DEPENDENCY ON CONJUGATE AND CONVECTIVE THERMAL BOUNDARY CONDITIONS IN PIN FIN CHANNEL

Direct Numerical Simulation of Condensing Stratified Flow

Numerical Investigation on Bubble Growth and Merger in Microchannel Flow Boiling with Self-Rewetting Fluid

Study on evaporation induced flow characteristics and interfacial phenomena of water in a sidewall-heated cylindrical pool at low pressures

Investigation And Modeling Of The In-Tube Heat Transfer Of Fluids At Supercritical Pressure During Heating

Poiseuille Rayleigh-Benard Convective Flow and Compressible Boundary Effects of Near-Critical Fluid in Microchannels

Investigating Enhanced Convection Heat Transfer in 3D Micro-Ribbed Tubes Using Inverse Problem Techniques