Abstract:A loop heat pipe is a passive heat transfer device with strong robustness, high efficiency, and good performance, and has been widely utilized in numerous thermal control systems. Herein, an intensive study of a flat-plate evaporator LHP from the perspective of experiment and simulation is presented. First, the vapor leakage problem, which was a common issue for most LHP systems, was solved by filling the assembly clearance with epoxy glue, and a flat-plate LHP system was fabricated to verify its operating performance. Test results indicated that the loop stably performed under various working conditions without temperature oscillation. The maximum heat flux was 11.25 W/cm2 and the minimum thermal resistance was 0.1340 degrees C/W. The heater surface temperature remained low except during the dry-out state in wick at the maximum heat load condition where a sharp increase was observed, and temperature hysteresis occurred during variable heat load tests owing to the transport lag in long liquid line. Based on the above experiment, an efficient 3-D CFD computational model was built to simulate the heat and mass transfer process in a flat-plate evaporator by the Volume of Fluid method. In addition, the flow regime with two-phase distribution at the scale of the entire evaporator was calculated by considering the structure effect. Boundary conditions were derived from the experiment and the mass flow rate at the evaporator inlet was deduced from the heat leakage effect in liquid line. Calculation results demonstrated that four symmetric vortices developed inside the compensation chamber and generated uneven subcooled liquid infiltration in wick, further leading to a slight offset of high-temperature zone to the evaporator inlet side. Parameter analysis indicated that the ribs conducted 84 % of the heat conduction using thermal paths formed between the heater surface and liquid-vapor interface. The vapor volume percentage in the vapor collector was above 80 %, and increasing the heat load reduced the vapor volume in wick as well as the percentage of heat adsorbed during evaporation. Experimental comparison illustrated that the model exhibited a high accuracy with an error less than 10.29 %.

Numerical Study on Thermohydraulic Behavior in Compensation Chamber of a Loop Heat Pipe with Flat Evaporator

Numerical Study and Parametric Analysis of Thermo-Hydraulic Behavior in a Flat Loop Heat Pipe at System Scale

Three-dimensional numerical simulation for heat and mass transfer of the evaporator in a flat miniature loop heat pipe

Numerical investigation on transient and steady phase change heat transfer in the evaporator of a loop heat pipe

Simulation of heat and mass transfer process in a flat-plate loop heat pipe and experimental comparison

A Flow Visualization Study On The Temperature Oscillations Inside A Loop Heat Pipe With Flat Evaporator

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Visualization Study on the Heat and Mass Transfer in the Evaporator-Compensation Chamber of a Loop Heat Pipe

Experimental Study on A Flat Loop Heat Pipe Coupling the Compensation Chamber and the Condenser

One-dimensional numerical study for loop heat pipe with two-phase heat leak model

Visualization Investigation on Temperature Oscillation and Two-Phase Behaviors of A Flat Loop Heat Pipe

Three-Dimensional Numerical Study on the Flow and Heat Transfer in Wick of Loop Heat Pipe

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

3D Heat Transfer Analysis in a Loop Heat Pipe Evaporator with a Fully Saturated Wick

Mathematical Modeling of Steady-State Operation of a Loop Heat Pipe

Numerical study of heat distribution in a disk-shaped evaporator of a loop heat pipe at steady-state operation mode

Dynamic modeling of a loop heat pipe with flat evaporator

Mathematical Model and Numerical Simulation of Flow and Heat Transfer in LHP's Capillary Wick with Azimuthal Vapor Grooves

Three-dimensional Simulation on Heat Transfer in the Flat Evaporator of Miniature Loop Heat Pipe

Modeling and experimental investigation of looped separate heat pipe as waste heat recovery facility

Numerical Investigation of High-Temperature Heat Pipes with Different Wick Structures under Non-Uniform Heating Boundary Conditions