Abstract:Different modes of degradation and aging processes that result in either chemical or morphological alteration in the polymer electrolyte membranes (PEM) during the course of fuel cell operation are of paramount importance of commercial acceptance. The effect of radicals on the PEM durability is of particular interest since a common feature of many hydrocarbon-based membranes is that the building block consists of sulfonic acid substituted aromatic rings, which are much more sensitive to radical attack than the Teflon-like backbone in perfluorinated sulfonic acid type materials. In this work, we attempt to provide answers to the hydroxyl radical initiated durability issues at the polymer electrolyte-electrode interface by analyzing the performance of some novel non-fluorinated membranes using a newly designed durability evaluation method which enables analysis under fuel cell-operating conditions. This method is able to separate the membrane evaluation process into cathode and anode half cell processes for individual analysis of their respective interfacial degradation passed through the catalyzed working electrodes and reference electrodes side of the MEA, and humidified oxygen was passed through the non-catalyzed counter electrode side. After full humidification of the MEA, the working electrodes were either held at the typical anode operating potential of PEMFC (0.1-0.2 V, vs. RHE) or left in open circuit potential condition for varied periods of time. After the test, membrane at the interface with the working electrodes was subjected to mortem analysis. The results were then compared with corresponding properties of the membrane before the test. the electrodes to the polymer membrane.Characterization Techniques. After the durability experiment, the MEA was uninstalled from the cell, and the working electrodes were carefully peeled away from the MEA. Anhydrous ethanol was used to facilitate the peeling process. The membrane samples with a size of 1cm x 5 cm were then washed thoroughly with deionized water before post mortem analysis. All FT-IR (ATR) spectra were collected from 64 scans at 4cm'1 resolution. Dry nitrogen gas was purged around the sample during the measurement to eliminate moisture in the air. Proton conductivities vere determined from the water vapor equilibrated membrane samples at 30°C using a four-probe conductivity cell setup described in our prior publication?15i. Intrinsic viscosity was chosen as a qualitative parameter reflective of changes in molecular weight of the membranes. The polymer solution was measured according to the single point method developed by Solomon and Ciuta[16] with an Ubbelohde viscometer in a 25°C water bath, using 1% lithium bromide inN-methylpyrrolidone (l%LiBr/NMP) as the solvent.

Embrittlement Induced Fracture Behavior and Mechanisms of Perfluorosulfonic-Acid Membranes after Chemical Degradation

A Kinetic Model for the Chemical Degradation of Perfluorinated Sulfonic Acid Ionomers: Weak End Groups Versus Side Chain Cleavage

Aspects of the Chemical Degradation of Pfsa Ionomers Used in Pem Fuel Cells

Fatigue crack propagation behavior of fuel cell membranes after chemical degradation

Degradation Behaviors Of Perfluorosulfonic Acid Polymer Electrolyte Membranes For Polymer Electrolyte Membrane Fuel Cells Under Varied Acceleration Conditions

Exploring the Role of Reinforcement in Controlling Fatigue Crack Propagation Behavior of Perfluorosulfonic-Acid Membranes

A Molecular Simulation Study of Chemical Degradation and Mechanical Deformation of Hydrated Nafion Membranes

Evaluating the Durability of Perfluorosulfonic Acid Membranes in Fuel Cells Using Combined Open-Circuit Voltage-Accelerated Stability Testing

XPS Analysis of Polymer Membrane Degradation in PEMFCs

A Degradation Study of Nafion Proton Exchange Membrane of PEM Fuel Cells

Revealing the Accelerated Crack Prolongation Behavior under Chemical Ionomer Degradation Within the Catalyst Layer

Durability and Performance Analysis of Polymer Electrolyte Membranes for Hydrogen Fuel Cells by a Coupled Chemo-mechanical Constitutive Model and Experimental Validation

Impact of Hygrothermal Aging on Structure/function Relationship of Perfluorosulfonic-Acid Membrane

The Degradation Study of Nafion/Ptfe Composite Membrane in Pem Fuel Cell under Accelerated Stress Tests

Effect of Pretreatment on Microstructure and Mechanical Properties of Nafion™ XL Composite Membrane

Ex Situ Investigation of the Proton Exchange Membrane Chemical Decomposition

Durability Issues at the Polymer Electrolyte Membrane and the Electrocatalyst Interface with Non-Fluorinated Ionomers

Effect of free radical-induced degradation on water permeation through PFSA ionomer membranes

Numerical and experimental characterization of gas permeation through membranes with consideration of mechanical degradation in proton exchange membrane fuel cells

Fracture Property of Nafion XL Composite Membrane Determined by R-curve Method

Mechanical behavior of a hydrated perfluorosulfonic acid membrane at meso and nano scales