Abstract:Different modes of degradation and aging processes that result in either chemical or morphological alteration in the polymer electrolyte membranes (PEM) during the course of fuel cell operation are of paramount importance of commercial acceptance. The effect of radicals on the PEM durability is of particular interest since a common feature of many hydrocarbon-based membranes is that the building block consists of sulfonic acid substituted aromatic rings, which are much more sensitive to radical attack than the Teflon-like backbone in perfluorinated sulfonic acid type materials. In this work, we attempt to provide answers to the hydroxyl radical initiated durability issues at the polymer electrolyte-electrode interface by analyzing the performance of some novel non-fluorinated membranes using a newly designed durability evaluation method which enables analysis under fuel cell-operating conditions. This method is able to separate the membrane evaluation process into cathode and anode half cell processes for individual analysis of their respective interfacial degradation passed through the catalyzed working electrodes and reference electrodes side of the MEA, and humidified oxygen was passed through the non-catalyzed counter electrode side. After full humidification of the MEA, the working electrodes were either held at the typical anode operating potential of PEMFC (0.1-0.2 V, vs. RHE) or left in open circuit potential condition for varied periods of time. After the test, membrane at the interface with the working electrodes was subjected to mortem analysis. The results were then compared with corresponding properties of the membrane before the test. the electrodes to the polymer membrane.Characterization Techniques. After the durability experiment, the MEA was uninstalled from the cell, and the working electrodes were carefully peeled away from the MEA. Anhydrous ethanol was used to facilitate the peeling process. The membrane samples with a size of 1cm x 5 cm were then washed thoroughly with deionized water before post mortem analysis. All FT-IR (ATR) spectra were collected from 64 scans at 4cm'1 resolution. Dry nitrogen gas was purged around the sample during the measurement to eliminate moisture in the air. Proton conductivities vere determined from the water vapor equilibrated membrane samples at 30°C using a four-probe conductivity cell setup described in our prior publication?15i. Intrinsic viscosity was chosen as a qualitative parameter reflective of changes in molecular weight of the membranes. The polymer solution was measured according to the single point method developed by Solomon and Ciuta[16] with an Ubbelohde viscometer in a 25°C water bath, using 1% lithium bromide inN-methylpyrrolidone (l%LiBr/NMP) as the solvent.

The Degradation Study of Nafion/Ptfe Composite Membrane in Pem Fuel Cell under Accelerated Stress Tests

Degradation Study of Membrane Electrode Assembly with PTFE/Nafion Composite Membrane Utilizing Accelerated Stress Technique

A Degradation Study of Nafion Proton Exchange Membrane of PEM Fuel Cells

A Polymer Electrolyte Fuel Cell Life Test Using Accelerating Degradation Technique

Proton exchange membrane fuel cell degradation under close to open-circuit conditions

Degradation Study and Diagnostic Technology for Nafion Membrane

Primary Study on Degradation Mechanism of Polystyrenesulfonic Acid Membrane and Its Composite Membrane in Fuel Cells

Durability Issues at the Polymer Electrolyte Membrane and the Electrocatalyst Interface with Non-Fluorinated Ionomers

Degradation Behaviors Of Perfluorosulfonic Acid Polymer Electrolyte Membranes For Polymer Electrolyte Membrane Fuel Cells Under Varied Acceleration Conditions

Investigation of mechanical degradation in catalyst-coated reinforced membranes under in-situ hydrothermal cycles

A Review of Accelerated Stress Tests of Mea Durability in Pem Fuel Cells

Accelerated Test Of Silicone Rubbers Exposing To Pemfc Environment

In Situ Analysis of Performance Degradation of A Pemfc under Nonsaturated Humidification

Degradation Characteristics of Membrane Electrode Assembly under Drive Cycle Test Protocol

Diagnosis of Membrane Electrode Assembly Degradation with Drive Cycle Test Technique

Investigation of Dynamic Driving Cycle Effect on Performance Degradation and Micro-Structure Change of PEM Fuel Cell

Development of Chemical and Mechanical Acceleration Stress Test Method for PEMFC Polymer Membranes

Degradation Study on Mea in H3po4/Pbi High-Temperature Pemfc Life Test

Durability Test Of Pemfc With Pt-Pfsa Composite Membrane

Degradation Mechanism of Polystyrene Sulfonic Acid Membrane and Application of Its Composite Membranes in Fuel Cells

Key Components Degradation in Proton Exchange Membrane Fuel Cells: Unraveling Mechanisms through Accelerated Durability Testing