Abstract:Conventional dry electrodes often yield unstable results due to the presence of parasitic capacitance between the flat electrode surface and the non-uniform skin interface. To address this issue, a gel is typically placed between the electrodes to minimize parasitic capacitance. However, this approach has the drawbacks of being unsuitable for repeated use, limited lifetime due to gel evaporation, and the possibility of developing skin irritation. This is particularly problematic in underserved areas since, due to the cost of disposable wet electrodes, they often sterilize and reuse dry electrodes. In this study, we propose a method to neutralize the effects of parasitic capacitance by attaching high-value capacitors to the electrodes in parallel, specifically when applied to pulse wave monitoring through bioimpedance. Skin capacitance can also be mitigated due to the serial connection, enabling stable reception of arterial pulse signals through bioimpedance circuits. A high-frequency structure simulator (HFSS) was first used to simulate the capacitance when injection currents flow into the arteries through the bioimpedance circuits. We also used the simulation to investigate the effects of add-on capacitors. Lastly, we conducted preliminary comparative analyses between wet electrodes and dry electrodes in vivo with added capacitance values ranging from 100 pF to 1 μF, altering capacitance magnitudes by factors of 100. As a result, we obtained a signal-to-noise ratio (SNR) that was 8.2 dB higher than that of dry electrodes. Performance was also shown to be comparable to wet electrodes, with a reduction of only 0.4 dB using 1 μF. The comparative results demonstrate that the addition of capacitors to the electrodes has the potential to allow for performance similar to that of wet electrodes for bioimpedance pulse rate monitoring and could potentially be used for other applications of dry electrodes.

An Interference Suppression Method for Non-Contact Bioelectric Acquisition

Power-line Interference Suppression in Electrocardiogram Using Recurrent Neural Networks.

Common-Mode Noise Reduction in Noncontact Biopotential Acquisition Circuit Based on Imbalance Cancellation of Electrode-Body Impedance

Evaluation Of Non-Contact Flexible Electrodes Connected With A Customized Ic -Steps Towards A Fully Integrated Ecg Sensor

Reduction in the Motion Artifacts in Noncontact ECG Measurements Using a Novel Designed Electrode Structure

Flexible Non-Contact Electrodes for Minimizing Artifacts in Electrocardiograms Measurement During Motion

Electrode Design for Electrotactile Feedback With Reduced Interference to Myoelectric Signal

An Active Electrode Design For Weak Biosignal Measurements

Effective Biopotential Signal Acquisition: Comparison of Different Shielded Drive Technologies

Ultra-High Input Impedance, Low Noise Integrated Amplifier for Noncontact Biopotential Sensing

Flexible Non-contact Electrodes for Bioelectrical Signal Monitoring.

Capacitive Coupled Electrodes Based Non-contact ECG Measurement System with Real-time Wavelet Denoising Algorithm

Capacitively Coupled Electrocardiogram Measuring System and Noise Reduction by Singular Spectrum Analysis

An External Interference-Resistant Noncontact Voltage Sensor with Negative Feedback Design

Performance of Flexible Non-contact Electrodes in Bioelectrical Signal Measurements.

A Novel Front-End Design for Bioelectrical Signal Wearable Acquisition

Removal of Electrocardiogram Artifacts from Local Field Potentials Recorded by Sensing-Enabled Neurostimulator.

A smart idea to reject motion artefacts from ECG measurements due to sensor-body impedance

Design on ear photoplethysmography sensor with movement interference cancellation

A Novel High Input Impedance Front-End for Capacitive Biopotential Measurement

Minimization of Parasitic Capacitance between Skin and Ag/AgCl Dry Electrodes