Abstract:The tribological performance of copper-based powder metallurgical material is much influenced by the interfacial bonding between the components and matrix. By adding Cu-coated or uncoated graphite particles as a lubricant, two types of copper-based powder metallurgical materials were prepared via spark plasma sintering (SPS). The hardness, relative density, and thermal conductivity of the two specimens were firstly measured. Using an inertial braking test bench and temperature measuring instrument, the average friction coefficients, instantaneous friction coefficients, and friction temperatures of the two specimens were tested under different test conditions, and the wear rates were calculated accordingly. Based on the analysis of surface morphologies and elements distribution after the tests, the mechanisms of wear and formation of friction films were discussed. The results show that with the lubricant of Cu-coated graphite, the hardness, relative density, thermal conductivity, and interfacial bonding between the graphite and matrix can be greatly improved. Under the same test condition, the average friction coefficient, wear rate, and friction temperature of the specimen with added Cu-coated graphite are both lower than those of the specimen with added uncoated graphite. The two specimens show different variation trends in the instantaneous friction coefficient during the tests, and the variation of the instantaneous friction coefficient at a high initial test speed is also different from that at a low initial test speed for each specimen. The two specimens also show differences in the continuity of friction film and the content of graphite and oxide in the friction film.

Differences in Mechanical Behaviors and Characteristics Between Natural Graphite/copper Composites and Carbon-Coated Graphite/copper Composites

Superior mechanical properties and wear resistance of copper/graphite metallic composites fabricated with fibrous copper powder

Deformation and Fracture Behavior of Electrocodeposited Alumina Nanoparticle/Copper Composite Films

Investigation of the mechanical behavior of the carbon nanotubes coated copper composite materials

Fretting wear behavior of brass/copper-graphite composites as a contactor material under electrical contact

Effect of carbon matrix on mechanical and tribological properties of Cf/Cu/C composites

Investigation of the Mechanical Properties of the Ni–P–CNTs Coated Copper Composite Materials: Experiments and Modeling

Characterization and Tribological Properties of Graphene/Copper Composites Fabricated by Electroless Plating and Powder Metallurgy

On the tribological behaviors of Cu matrix composites with different Cu-coated graphite content

Enhanced mechanical and tribological properties of copper matrix composites reinforced by copper-coated graphite and Ti3AlC2

Fabrication and tribological properties of carbon fiber and copper fiber reinforced carbon-based composite by hot pressing

Effect of Copper-Plated Graphite Content on the Microstructure and Properties of Copper-Graphite Composites Prepared by Spark Plasma Sintering

Tribological Properties of Carbon-Nanotube-reinforced Copper Composites

Mechanical behaviors of graphene/copper matrix composite foils fabricated by pulse electrodeposition

Study on the Tribological Performance of Copper-Based Powder Metallurgical Friction Materials with Cu-Coated or Uncoated Graphite Particles as Lubricants

Effect of counterpart materials on tribological behaviors of copper impregnated carbon/carbon composite under electric current condition

Study of Friction and Wear Properties of Cu/Short Carbon Fibers Composites

Fabrication, mechanical and thermal properties of tungsten-copper coated graphite flakes reinforced copper matrix composites

Fabrication and tribological behaviors of copper fiber and carbon fiber reinforced phenol‐formaldehyde resin‐based composite for sliding current collector

Effect of Bimodal Structure on the Frictional Properties of Copper–Graphite Composites

High strength and conductivity copper matrix composites reinforced by in-situ graphene through severe plastic deformation processes