Abstract:This paper reports that starter block with smaller diameter has better optimization effect of grain orientation during directional solidification of nickel‐based single‐crystal superalloy, and the single‐crystal appears at less than half‐turn position of spiral passage. Based on this, a spiral grain selector with optimized geometry is designed which is beneficial to practical production. A spiral grain selector with excellent geometric parameters can ensure qualified single‐crystal (SX) is selected while decreasing lesser thermal gradient (G) during casting of SX nickel‐based superalloy . In this paper, three configurations of spiral grain selectors with different height of starter block (H = 18, 25, 35 mm) and same spiral passage are adopted. Based on the quantitative analysis of orientation distribution of grains in starter block, it is found that the deviation of oriented grains in the projection zone of spiral passage inlet (circle with a diameter of 4 mm) are smaller than grains of overall cross‐section (circle with a diameter of 10 mm), which verify that starter block with smaller diameter have better optimization effect of grain orientation. Moreover, the average deviation of oriented grains decreases to a range of 6.6–10.8° when the height of starter block is 18–27 mm, and SX selection is completed on the position of less than half turn in spiral passage regardless of the number of grains in the inlet position. Finally, a modified spiral grain selector is designed from the perspective of practical production, of which total height is reduced by at least 15 mm, and can decrease lesser G at some extent during casting .

Grain Orientation Optimization Of Two-Dimensional Grain Selector During Directional Solidification Of Ni-Based Superalloys

Grain Selection in a High-Efficiency 2D Grain Selector During Casting of Single-Crystal Superalloys

Orientation Control for Nickel-Based Single Crystal Superalloys: Grain Selection Method Assisted by Directional Columnar Grains

A Study of Grain Selection in Two-Dimensional (2D) Grain Selectors during the Investment Casting of Single-Crystal Superalloy

Grain Selection During Casting Ni-Base, Single-Crystal Superalloys with Spiral Grain Selector

2-D Selector Simulation Studies On Grain Selection For Single Crystal Superalloy Of Cm247lc

Substrate stimulating technique for Ni-based single crystal superalloy preparation during direction solidification

Simulation of grain selection during solidification of Ni base single crystal superalloy in spiral grain selector

Simulation of Grain Selection During Single Crystal Casting of A Ni-Base Superalloy

Numerical Simulation of Grain Selection Behavior of Single Crystal Ni3al Based Superalloy Casting

Orientation controlling of Ni-based single-crystal superalloy by a novel method: grain selection assisted by un-melted reused seed

Investigation of Grain Competitive Growth During Directional Solidification of Single-Crystal Nickel-Based Superalloys

A Geometry Optimization of Spiral Grain Selector During Directional Solidification of Nickel‐Based Superalloy

Competitive Grain Growth Mechanism in Three Dimensions During Directional Solidification of A Nickel-Based Superalloy

Simulation And Experimental Studies On Grain Selection And Structure Design Of The Spiral Selector For Casting Single Crystal Ni-Based Superalloy

Modes of Grain Selection in Spiral Selector during Directional Solidification of Nickel-base Superalloys

Ebsd Studies of Grain Evolution and Grain Selection Behavior During the Preparation of Ni-Based Single Crystal Superalloy Dd3

The Effect of Substrate Orientation on Stray Grain Formation in the (111) Plane in Laser Surface Remelted Single Crystal Superalloys

The Influence of Grain Boundary Angle on the Hot Cracking of Single Crystal Superalloy DD6

Numerical Simulation and Experimental Study on Spiral Grain Selector in Directional Solidification of Single Crystal Superalloy

Numerical Simulation and Experimental Grain Selection of DD6 Superalloy in Spiral Grain Selector by Directional Solidification