Abstract:Modeling the behavior of suspended particles in gaseous phase is important for diverse reasons; e.g. aerosol is usually the main subject of CFD simulations in clean rooms. Additionally, to determine the rate and sites of deposition of particles suspended in inhaled air, the motion of the particles should be predicted in lung airways. Meanwhile there are two basically different approaches to simulate the behavior of particles suspension, Lagrangian and Eulerian approaches. This study compares the results of these two approaches on simulating the same problem. An in-house particle tracking code was developed to simulate the motion of particles with Lagrangian approach. In order to simulate the same problem with Eulerian approach, the solution to the transport equation with appropriate initial and boundary conditions was used. In the first case study, diffusion of particles, initially positioned homogeneously on an infinite plane was modeled with both approaches and the results were compared and the mismatch between Lagrangian and Eulerian approaches was analyzed for different concentrations. In the second case study, airflow with parabolic velocity profile moving between two parallel plates was modeled with two approaches. The airflow initially contained a homogeneous suspension of particles and the plates were maintained at zero concentration. The concentration along the plates was compared between the two approaches and the differences in the performance of each approach were investigated, again for different initial concentrations. The overall results confirm that as particle concentration falls below a minimum amount, approximately 105 m−2, the results of the two approaches deviate considerably from each other and hence the Eulerian approach cannot be taken as an alternative for Lagrangian approach for low concentrations. For the third problem, we investigated the 3D particle flow in an expanding lung alveolus. It is shown that when the number of total released particles increases, the results of Eulerian approach can be used as an alternative to Lagrangian simulation. Since the number of particles existing in the lung alveolus in normal condition is much lower than this value, we concluded that Eulerian method cannot be applied to problems involving low concentration of particles. Although, the results of the Lagrangian problem may converge to the Eulerian one by increasing simulation time, but it is a hypothetical situation which not really exist in short time scale problems such as third case study in this paper.

Robust and Efficient Prediction of the Collection Efficiency in Icing Accretion Simulation for 3D Complex Geometries Using the Lagrangian Approach I: an Adaptive Interpolation Method Based on the Restricted Radial Basis Functions

Advances in Cryogenic Engineering: Volumes 35A and B

Computation of Hypersonic Transitional Flows Over Cones Using Gas-Kinetic Scheme Coupled with the Turbulence Model

An Improved CIP-based Numerical Model for Simulating Free-Surface Flow with Adaptive Mesh

Research on the Methods for Obtaining Droplet Impingement Characteristics in the Lagrangian Framework

A Numerical Study of Droplet Impingement for In-Flight Ice Accretion Prediction

Influence of Air Flow Field Computation on an Ice Accretion Simulation of Airfoils

Fast predicting the trajectory of chip-like particles by integrating a discrete element method model with a computational fluid dynamics-based aerodynamic database

Analysis of Numerical Methods for Droplet Impingement Characteristics under Aircraft Icing Conditions

Animating Turbulent Fluid with a Robust and Efficient High‐order Advection Method

Aerodynamic prediction and roughness implementation toward ice accretion simulation

Efficient Radial Basis Function Mesh Deformation Methods for Aircraft Icing

Droplet Collection Efficiency Regularity of NACA0012 Airfoil Based on the Eulerian Method

A High-Precision Calculation Method for Interface Normal and Curvature on an Unstructured Grid.

Development of a 3D Eulerian/Lagrangian Aircraft Icing Simulation Solver Based on OpenFOAM

Finite volume based film flow and ice accretion models on aircraft wings

Numerical Simulation of Iced Wing Using Separating Shear Layer Fixed Turbulence Models

Ice accretion simulation incorporating roughness effects and separation correction through a transition model

A GPU accelerated three-dimensional ghost cell method with an improved implicit surface representation for complex rigid or flexible boundary flows

A New Ice Accretion Model for Aircraft Icing Based on Phase-Field Method

Aerodynamic Prediction of Iced Airfoils Based on Modified Three-Equation Turbulence Model