Abstract:Currently, with the increasing trend towards miniaturization and thinning of semiconductor devices, ensuring product reliability has become a crucial aspect in electronic packaging. This paper specifically focuses on MEMS temperature and humidity sensors and utilizes Moldex3D software for three-dimensional mold flow simulation analysis. The purpose of the analysis is to predict the distribution of potential air traps and identify the locations of weld lines. The influence of gate location and gate quantity on process defects and reliability issues is investigated using a single-factor method. The results clearly indicate that the design of the gate system has a significant impact on the reliability of sensor packaging. The simulation results for different gate locations demonstrate that placing the gate in the middle achieves a more balanced flow of epoxy resin. However, insufficient filling pressure in this configuration may result in an increase in the occurrence of air traps and weld lines. When multiple gates are used in the simulation, it is observed that the number of air traps does not decrease with an increase in the quantity of gates. Nonetheless, multiple gates promote a more balanced resin flow, although some convergence occurs, leading to the generation of numerous air traps at the convergence points. Additionally, excessive injection pressure can cause overflow and wire shifting at the window opening of the temperature and humidity sensor. In conclusion, the design of the gate system should carefully consider the structural characteristics of the product and the transfer molding process. It is evident that the gate system design plays a crucial role in the formation of air traps and weld lines. Therefore, a rational gate system design is vital to ensure both the yield and reliability of sensor products.

A Novel Packaging Stress Isolation Chip for MEMS Devices

Evaluation of Die Stress in MEMS Packaging: Experimental and Theoretical Approaches

Low stress packaging of a micromachined accelerometer

Thermal stress of MOEMS Accelerometers Based on Grating Interferometric cavity

Accurate Assessment of Packaging Stress Effects on MEMS Sensors by Measurement and Sensor–Package Interaction Simulations

Research on the Stress in Stacked Chip Packages

Research on Stress in Flip Chip Packaging with Silicon Piezoresistive Stress Sensor

Application of silicon stress sensor in flip chip packaging system

Stress Monitoring in Flip Chip Packaging Process

Tracking in-die mechanical stress through silicon embedded sensors for advanced packaging applications

Design, Test and Evaluation of a Novel Die-Attach Structure for Packaging Stress Suppression of MEMS Resonant Accelerometers

Chip Level Packaging for Mems Using Silicon Cap

Fabrication and Characterization of Low Stress Si Interposer with Air-Gapped Si Interconnection for Hermetical System-in-Package

Thermal Deformation Suppression Chip Based on Material Symmetry Design for Single Center Supported MEMS Devices

Investigation on the effect of the packaging-induced stress on the reliability of a MEMS sensor package

A strategy of wafer-level-plastic-packaging for MEMS based on adhesive bonding

A SOI Sandwich Differential Capacitance Accelerometer with Low-Stress Package

Study of Local Stress Using Stress-Absorbing Si Diaphragm

The flexible package and applications of ultra-thin sensor chip

Characterization of Residual Stress in SOI Wafers by Using MEMS Cantilever Beams

Packaging Effect on MEMS Pressure Sensor Performance