Mesoscopic modeling and simulation of tensile properties of cracked concrete using cohesive model
Yang Li,Zhibin Hao,Zihao Shen,Pei Fu,Jiangkun Zhang
DOI: https://doi.org/10.1016/j.cscm.2023.e02186
IF: 4.934
2023-06-08
Case Studies in Construction Materials
Abstract:A random aggregate (RA) model consisting of mortar, aggregate, and the interfacial transition zone (ITZ) was established to investigate the effect of existing cracks on the tensile properties of concrete. Based on this, a method for establishing a geometric model of cracked concrete was proposed by inserting 0-depth cohesive elements into the RA model. The influence of crack length, width, and area on the tensile properties of concrete were studied using the established cracked concrete model. In addition, the key parameters of bond strength and fracture energy of the mortar and ITZ regions were tested. The cement is ordinary Portland cement with a strength grade of 42.5, and the sand is medium sand. The fracture energy tests were conducted using a displacement-controlled loading model with a loading rate of 0.4 mm/min, while the tensile strength tests were conducted using a stress-controlled loading method with a loading rate of 0.06 MPa/s. The feasibility and accuracy of the numerical method used were verified by comparing the results with those of a finite compression simulation. The numerical results show that as the crack length increases, the tensile strength and elastic modulus of concrete gradually decrease, but if the crack length is 0.47 h, the elastic modulus of concrete shows an abnormal increase. The range of the crack's influence on the tensile performance of concrete is between 50 mm and 100 mm. If the crack width is less than 0.55 mm, the tensile strength of concrete gradually decreases with the increase of crack width, and when the crack width is greater than 0.55 mm, the tensile strength stabilizes.
construction & building technology,materials science, multidisciplinary,engineering, civil