Abstract:In this study the effect of thermomechanical treatments in chloride induced pitting corrosion is presented for carbon steel rebars exposed to synthetic fly ash (FA) pore solution. Due to the likely phase transformations that steel reinforcements in concrete experience during the event of a fire, the understanding of the corrosion behavior of such phases is key in predicting the stability of the structure. The motivation for this study arrives from the scarce literature regarding the corrosion behavior of thermomechanically treated steel reinforcements in FA environments and the need for further investigation to understand its mechanism. In order to better understand the effects on the corrosion behavior electrochemical measurements including cyclic potentiodynamic polarization curves (CPP) and electrochemical impedance spectroscopy (EIS) were used. It was found that quenched specimens showed enhanced corrosion kinetics as their icorr values were higher, being of 3.18 × 10−5 and 2.20 × 10−5 A/cm2 for water and oil quenched compared to 2.13 × 10−6 A/cm2 for the as-received. Furthermore, the effective capacitance of the double layer (Ceff,dl) showed the lower stability of the passive film for the quenched specimens, with values of 1.11 × 10−3 μF/cm2 for the as-receive sample that decreased to 8.12 × 10−4 μF/cm2 for the water quenched sample. The anodic charge transfer coefficient in the synthetic FA alkaline pore solution changes from 0.282 to 0.088, for the as-received and water quenched rebars specimens, respectively. These results indicate a lower energy barrier for the anodic dissolution reaction of quenched specimens, indicating that martensite and bainite microstructures promote corrosion process. Enhanced corrosion was found on quenched samples presenting martensite and bainite microstructure as showed by the increased pith depth, with values of 5 μm compared to 1 μm observed in the as-received samples.

Characterization of the Passive Film Formed on the Reinforcement Surface in Alkali Activated Fly Ash: Surface Analysis and Electrochemical Evaluation

Surface characteristics and electrochemical behaviors of passive reinforcing steel in alkali-activated slag

Corrosion Behavior of the Reinforcement in Chloride-Contaminated Alkali-Activated Fly Ash Pore Solution

The Electrochemical Characterization of Rebar Passivation Film in Simulated Concrete Media

Chloride transport resistance of alkali-activated concrete exposed to combined chloride, sulfate and carbonation environment

Influence of Thermomechanical Treatments on Corrosion of Carbon Steel in Synthetic Geopolymer Fly Ash Pore Solution

Microstructure and Corrosion Behavior of the Ultra-Fine Grained Aluminum Coating Fabricated by Friction Surfacing

Pore Solution Chemistry of Calcium Sulfoaluminate Cement and Its Effects on Steel Passivation

Structure and Composition of the Passive Film Studied Using a Combination of X-Ray Photoelectron Spectroscopy, Secondary Ion Mass Spectrometry, and Scanning Transmission Electron Microscopy

A numerical study on chloride transport in alkali-activated fly ash/slag concretes

Passive film and surface characterization of Alx(CoCrFeNi)100-x (x = 0, 5, 10, 15, 20) high entropy alloys

Corrosion Resistance, Composition, and Stratification of Passive Films: Ni-22Cr and Ni-22Cr-6Mo Alloys Passivated and Exposure Aged in Acidic Chloride Solutions

STATIC CORROSION BEHAVIOR OF IN-SITU NANOCRYSTALLINE Al2O3/Fe(Al) COMPOSITES

Fabrication and characterization of anodic films onto the FeCrAl stainless steel in ethylene glycol electrolyte

Enhanced corrosion protection of rebars in alkaline solutions by ferroporphyrin and the mechanisms of electron consumption and lattice reconstruction

AN XPS STUDY OF Cr-Al COMPOSITE PASSIVE FILMS

Surface modification and interface strengthening strategies for fly ash and its application in anti-corrosion coatings

Texture evolution and corrosion behavior of the AA6061 coating deposited by friction surfacing

Corrosion and passive behavior of Al0.8CrFeNi2.2 eutectic high entropy alloy in different media

Microstructure, strength development mechanism, and CO2 emission analyses of alkali-activated fly ash-slag mortars

Alkali-activated concretes based on high unburned carbon content fly ash: carbonation and corrosion performance