Abstract:The modular multilevel converter (MMC) with nearest level modulation (NLM) is widely used in the high voltage applications for low switching frequency and easy implementation. Existing literature has not provided a complete submodule (SM) fault ride-through scheme for MMC with NLM. In this paper, a strategy including fault detection, localization, redundancy, and recovery is proposed to ensure continuous operation of MMC under IGBT open-circuit faults conditions. It only requires a few hardware and software resources. The features of MMC and SMs with three types of failures are studied, respectively. Based on these, the fault detection method is proposed by using a simple hardware circuit, thus high computation complexity is avoided. Since current fault localization schemes are limited to MMC with carrier phase shifted pulse width modulation, this paper further proposes a strategy for MMC with NLM to locate the faulty SM and identify the fault type. After this, the fault redundancy and the proposed fault recovery method are applied to eliminate the fault and then exit the failure state. Therefore, the ability of SM fault ride-through can be realized. Analysis of failure characteristics are verified in simulation. Experimental results based on a single-phase MMC prototype with 11 SMs per arm are presented to demonstrate the validity of the proposed fault ride-through strategy.

Fault Localization Strategy for Modular Multilevel Converters Under Submodule Lower Switch Open-Circuit Fault

Open-circuit Faults Localization with error elimination for Modular Multilevel Converters under various control modes

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

A Submodule Fault Ride-Through Strategy for Modular Multilevel Converters with Nearest Level Modulation

Redundancy Fault-tolerated Control Strategy for Sub-module Faults of Modular Multilevel Converters

A Threshold Adaptive Open-Circuit Submodule Fault Diagnosis Strategy for Modular Multilevel Converters

Submodule Open-Circuit Fault Detection For Modular Multilevel Converters Under Light Load Condition With Rearranged Bleeding Resistor Circuit

The Unified Model and Optimal Operation Analysis for A Modular Multilevel Converter

The Fault Detection, Localization, and Tolerant Operation of Modular Multilevel Converters with an Insulated Gate Bipolar Transistor (IGBT) Open Circuit Fault

Unified Strategy for Fault-Tolerant Operation of MMC with Multiple SMs Failure Based on SMs Grouping Management

Control Strategy For Modular Multilevel Converters In Sub-Module Fault State

Fault-Tolerant Control of Medium-Voltage Modular Multilevel Converters with Minimum Performance Degradation under Submodule Failures

Switch Open-Circuit Fault Detection and Localization for Modular Multilevel Converters Based on Signal Synthesis

Analysis and Control of Three-Phase Modular Multilevel Converters under the Single Arm Fault Condition

Characteristic Analysis and Fault-Tolerant Control of Circulating Current for Modular Multilevel Converters under Sub-Module Faults

The Evolution and Variation of Sub-Module Topologies with DC-fault Current Clearing Capability in MMC-HVDC

Fault-tolerant strategy for modular multilevel converter with nearest level modulation in HVDC system

Detection and Localization of Submodule Open-Circuit Failures for Modular Multilevel Converters with Single Ring Theorem

A Fault Tolerant Control For Modular Multilevel Converter Under Submodule Fault Conditions

Fault Diagnosis and Tolerant Control of Single Igbt Open-Circuit Failure in Modular Multilevel Converters

Introduction, Modeling and Simulation of Modular Multilevel Converter