Abstract:The existing I 2 C interfaces require significant CPU intervention for data communication. In SOC systems, when using internally integrated I 2 C modules as masters, software control of I/O ports is necessary to emulate the I 2 C protocol for data transmission. This paper proposes a Mini I 2 C bus interface circuit design scheme that supports both master and slave modes. The I 2 C interface features minimal CPU intervention during data transmission, ease of use, small circuit area, and low power consumption. Additionally, the internal state machine design employs independent finite state machines (FSMs) for master and slave modes, enabling flexible configuration of the I 2 C module to operate in either mode. In comparison to reference (ShenZhen in Microelectronics Technology CO.BJ8M306A, Datasheet.2019.12.2., 2019), the proposed I 2 C solution reduces CPU instructions by 50% during data transmission, and by 33% compared to reference (GigaDevice Semiconductor Inc. GD32F1x0, Datasheet, 2022). After DC synthesis, the proposed design occupies only 14% of the area and consumes only 3.6% of the power of the Open Source I 2 C Design (Forencich in verilog-i2c. GitHub repository. Retrieved from https://github.com/alexforencich/verilog-i2c, n.d.). Therefore, this design scheme is better suited for low-power systems. The proposed design was validated through simulation using Xilinx ISE 14.7 with a SPARTAN 3 FPGA model xc3s500e-5pq208, and finally implemented using Huahong 95 nm CMOS technology, demonstrating high integration and low power consumption.

A Lightweight Slave-Module Interface Core to Implement IEEE 1149.5 MTM-Bus Based on FPGA

Design and FPGA Verification of a Novel Reliable Real-Time Data Transfer System

Design and implementation of controller for a sensor network protocol

The Implementation and Performance Analysis of an Ethernet Embedded System Based on a Microcontroller

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

The Design and Implementation of PC/104-Compatible Interface and Traffic Store Hardware in a Class 4MVB Controller

Design and Implementation of FPGA Based High-Speed Bus for Control System

Design and Implementation of Ultra-Low Power I2C-Compatible Bus based on Asynchronous Circuit

A mini I2C bus interface circuit design and its VLSI implementation

Romote Test System of FPGA based on USB and LVDS

An on-chip interconnect mechanism for multi-processor SoC

Design and Implementation of Network Communication Interface Based on Μclinux

Design and Implementation of USB1.1 Controller

Design and Implementation of LWIP Ethernet Based on SOPC AXI Bus

A Lightweight and High-Throughput Asynchronous Message Bus for Communication in Multi-Core Heterogeneous Systems

Design of an IIC Bus Controller IP Core

Design and Implementation of High Integrated AM80486 CPU Based on PCI Controller

Study Of Tdma-Based High-Speed Simplified Serial Bus

A Lightweight SPI-Flash Controller Based on AMBA AHB-Lite Bus

Research and Design of Bus Analysis Controller for Multifunction Vehicle Bus Based on FPGA

A CAN-based protocol for reliability testing of embedded software