Abstract:Purpose This paper aims to analyze the dominant stray parameters of the DC bus bar and focus on weakening the influence of the stray parameters instead of reducing the value of the stray parameters in DC bus bar while switching. By finding the mechanisms to reduce the effects of stray parameters on switching transient, the simple and straightforward optimization methods could be given for the engineering designer. Design/methodology/approach The investigations are focused on the equivalent circuit by segmented impedance evaluation in the low-frequency band and the energy propagation by wave impedance evaluation in the high frequency band. This paper proposes an equivalent impedance calculation model to locate the dominant stray parameters in the DC bus bar and takes the energy propagation characteristics using wave impedance into consideration, which can simplify the optimization design of DC bus bar. Findings According to the equivalent circuit and electromagnetic field analysis, this paper proves the existence of the dominant stray parameters in DC bus bar that is widely used on high-power converters and certifies that not all the stray parameters in different areas of DC bus bar have the same effects on switching process, which can give a good guidance for the optimization design of DC bus bar. Originality/value The positions of DC-link capacitors, resulting in only part of stray parameters in DC bus bar has more impact during switching, are significant to the DC bus bar optimization design. These stray parameters named dominant stray parameters in this paper play a leading role in the switching transient process. The area of DC bus bar, which is close to IGBTs and far from DC-link capacitors, contains the dominant stray parameters in the switching transient process. Therefore, the distance between DC-link capacitors and IGBTs should be shortened as much as possible. Based on the results, the efficiency for the DC bus bar optimization design could be improved by weakening the influence of the stray parameters, such as reducing the dominant stray parameters only. Therefore, it can save the cost and time of DC bus bar optimization design.

Optimization of DC-Link Capacitance Based on the Power Loss Modeling of IGBT for Inverters Under Swing Bus Operation

Design of a 200kVA Soft-switching IGBT Three-phase Inverter

Improved Switching Loss Calculation in Neutral Point Clamped Inverter Via Waveforms Linearization

Modeling and Optimization of a Zero-Voltage Switching Inverter for High Efficiency and Miniaturization

Mission Profile Based Sizing of Igbt Chip Area for Pv Inverter Applications

Evaluation of Power Losses in Different CCM Mode Single-Phase Boost PFC Converters Via a Simulation Tool

Study On Planar Busbar Regarding Stray Inductance Minimization And Oscillation Suppression For High Power Converter

Quasi-Online Modeling Method of the Power Inverter Losses Based on IGBT Offline Test Platform

A Coupled 3D FEM-Distribute Circuit Model for Numerical Analysis of Small Time Scale Transients of an IGBT based Inverter

Optimizing Capacitance in Spwm Converter/Inverter for Series Hybrid Electric Bus Systems

Analysis and compensation of dead-time effect in voltage source inverters considering parasitic capacitance and ripple current

Current Sharing Analysis and Evaluation of Parallel DC-Link Capacitors in Vehicle Motor Drive

Capacitor Voltage Ripple Reduction of A 4-Level Hybrid Clamped Converter Using Switching State Redundancy for Medium-Voltage Drive

Dc-Voltage Fluctuation Elimination Through A Dc-Capacitor Current Control for Dfig Converters under Unbalanced Grid Voltage Conditions

Analysis of DC Bus Bar Dominant Stray Parameters Based on Equivalent Calculation Models

Modeling of Conduction and Switching Losses for IGBT and FWD Based on SVPWM in Automobile Electric Drives

Analysis of Inverter IGBT Losses of C-filter LCC Operating in DCM

The Analysis of Surge Voltage in Three-phase IGBT Inverters

Commutation Behavior and Stray Inductance Analysis of a FC-3L-BDC Phase-Leg PEBB

Design, Simulation and Analysis of the Low Stray Inductance Bus Bar for Voltage Source Inverters

Optimization of Power Sharing and Switching Frequency in Si/WBG Hybrid Half-Bridge Converters using Power Loss Models