Abstract:Wet gas is commonly encountered in various industries, including energy, chemical, and electric power sectors. For example, natural gas extracted from production often contains small amounts of liquid, such as water and hydrocarbon condensates, which classifies it as wet gas. The presence of liquid within the gas poses challenges for accurate flow measurement. To improve the performances of wet gas flow metering methods, significant research and development efforts have been invested into the wet gas flow metering technologies due to their vital importance in the production, transfer, and trade benefits. This paper presents a comprehensive overview of the recent development of wet gas flow metering. Firstly, a comprehensive discussion of the Lockhart-Martinelli parameter (Xlm) and its relation to the gas void fraction (αg) is presented, which was mostly overlooked in previous wet gas research work. The occurrence of various flow patterns in wet gas conditions at different orientations (horizontal and vertical) was explored. Following an investigation of pressure impact on the wet gas flow patterns and development of the wet gas regions, a different test matrix for further research work was suggested. After a novel classification of wet gas measurement methods, the paper offers a detailed comparison of differential pressure (DP) meters including Venturi, Cone meter, and orifice meters, by considering both liquid and gas flow rate measurements. Secondly, the paper discusses and compares vortex flow meters, Coriolis and ultrasonic meters in comparison to DP meters. Notable phase fraction meters are also examined and compared to one another. Thirdly, the paper reviewed the concept of existing and potential hybrid wet gas meters, conducting a detailed discussion and comparison with commercial solutions by evaluating their ranges and accuracies. This assessment provides valuable insights into the capabilities of these hybrid meters, highlighting their potential to enhance the measurement of wet gas flow rates.

Pressure Drop of Wet Gas Flow with Ultra-Low Liquid Loading Through DP Meters

Gas and Liquid Flow Rate Measurement in Wet Gas Based on Differential Pressure Signals

Wet Gas Metering by Using A Long-Throat Venturi Meter

On fluctuation of the dynamic differential pressure signal of Venturi meter for wet gas metering

A New Model for the V-Cone Meter in Low Pressure Wet Gas Metering

Wet Gas Flow Metering Based on Differential Pressure and BSS Techniques

Comparison of Throttle Devices to Measure Two-Phase Flowrates of Wet Gas with Extremely-Low Liquid Loading

Two-Phase Pressure Drop Prediction in Wet Gas Flow Through V-Cone Meter

Comparison of the Two-Phase Mass Flow Coefficient and the Over-Reading for Wet Gas Flow Metering with DP Meters

Wet gas flow modeling for a vertically mounted Venturi meter

Devices and Methods for Wet Gas Flow Metering: A Comprehensive Review

Online Measurement of Gas and Liquid Flow Rate in Wet Gas Through One V-Cone Throttle Device

Wet-Gas Flow Modeling for the Straight Section of Throat-Extended Venturi Meter

Study on Wet Gas Online Flow Rate Measurement Based on Dual Slotted Orifice Plate

Error Analysis of Gas and Liquid Flow Rates Metering Method Based on Differential Pressure in Wet Gas

A New Correlation of Wet Gas Flow for Low Pressure with a Vertically Mounted Venturi Meter

High GVF and Low Pressure Gas–liquid Two-Phase Flow Measurement Based on Dual-Cone Flowmeter

Oil-water two-phase flow measurement based on differential pressure

Flow rate measurement of gas-liquid annular flow through a combined multimodal ultrasonic and differential pressure sensor

Online Measurement of Gas and Liquid Flow Rate in Wet Gas Base on Single V-cone Throttle

Prediction of differential pressure f slotted orifice for wet gas stratified flow