Investigation of the effect of the grain sizes on the dynamic strength of the fine-grained alumina ceramics obtained by Spark Plasma Sintering
Melekhin N. V.,Boldin M. S.,Bragov A. M.,Filippov A. R.,Popov A. A.,Shotin S. V.,Nokhrin A. V.,Chuvil'deev V. N.,Murashov A. A.,Tabachkova N. Yu.,Melekhin N.V.,Boldin M.S.,Bragov A.M.,Filippov A.R.,Popov A.A.,Shotin S.V.,Nokhrin A.V.,Chuvil'deev V.N.,Murashov A.A.,Tabachkova N.Yu.
DOI: https://doi.org/10.48550/arXiv.2204.10401
2022-04-21
Materials Science
Abstract:The results of dynamic strength tests of the alumina ceramics with various grain sizes are presented. The ceramics were obtained by Spark Plasma Sintering (SPS) of industrial submicron and fine Al2O3 powders. The heating up was performed with the rate of 10 oC/min; the grain sizes in the ceramics was controlled by varying the SPS temperature and the heating rate as well as by varying the initial sizes of the Al2O3 particles in the powders. The ceramics had a high density (over 98%) and a uniform fine-grained microstructure (the mean grain sizes varied from 0.8 to 13.4 mkm). The dynamic compressing tests were carried out by modified Kolsky method with using split Hopkinson pressure bar. The tests were performed at room temperature using a 20-mm PG-20 gas gun with the strain rate of ~10^3 s-1. The dependence of the dynamic ultimate strength of alumina on the grain size was found for the first time to have a non-monotonous character (with a maximum). The maximum value of the dynamic ultimate compression strength (SY = 1060 MPa) was provided at the mean grain size of ~2.9-3 mkm. The reduction of SY for alumina in the range of submicron grain sizes was shown to originate from the reduction of the relative density of the ceramics sintered at lower SPS temperatures.