An Improved Single Probe Method for Sap Flow Measurements Using Finite Heating Duration

Ruiqi Ren,Jonas von der Crone,Robert Horton,Gang Liu,Kathy Steppe
DOI: https://doi.org/10.1016/j.agrformet.2019.107788
IF: 6.2
2019-01-01
Agricultural and Forest Meteorology
Abstract:Because of its low cost and simple fabrication, it is easy to advocate for the single probe method as a method of choice in sap flow studies. An improved single probe method with finite heating duration (F-SPHP) is verified both in cut stem segments and in the field using mature beech (Fagus sylvatica L.) trees. The F-SPHP method is based on an analytical solution of the partial differential equation for combined heat conduction and convection, which shows large relative sensitivity to thermal conductivity (K). The F-SPHP method is able to measure sap flux densities (SFD) between 2 and 36 cm(3) cm(-2) h(-1) (heat pulse velocity (V-h): 3-60 cm h(-1)) in the cut stem egment experiment. This is an improvement compared to the instantaneous single probe heat pulse (I-SPHP) method which cannot accurately measure low (V-h < 20 cm h(-1)) sap flow. Sapflow+ (a four-needle heat pulse method) is used for field validation, and when compared with gravimetric measurements, slopes of 0.853 and 0.730 are obtained for F-SPHP and Sapflow+, respectively. Patterns measured with F-SPHP and Sapflow+ in mature beech trees in the forest are similar at all measurement positions and temperature correction is needed for both methods when natural temperature gradients are steep. Compared with multi-probe methods, the single probe method with finite heating duration has the advantage of causing less damage to conductive tissue.
What problem does this paper attempt to address?