Abstract:Near-field high-resolution synthetic aperture radar (SAR) imaging is mostly accompanied by a large number of data acquisition processes, which increases the system complexity and device cost. According to extensive reports, reducing the number of sampling points of a radar in space can greatly reduce the amount of data. However, when spatial sparse sampling is carried out, a ghost normally appears in the imaging results due to the high side lobes generated in the azimuth. To address this issue, a technique is introduced in this paper to recover the blank data through amplitude and phase compensation based on the correlation between sparse array sampling through adjacent points. Firstly, the data sampled by the sparse array is compressed in the range direction to obtain the expected data slices in the same range direction. Then, the blank element of the slice is compensated for with amplitude and phase to obtain full aperture data. Finally, the matched filter method is used to aid in the image reconstruction. The simulation results verified that the method proposed in this paper can effectively reconstruct the image under two kinds of sparse sampling conditions. Thus, a simple single-input single-output (SISO) synthetic aperture radar imaging test bench is established. Compared with the results of a 1 mm (1/4 λ) sampling interval, the quality of the reconstructed image under the condition of a 4 mm (1 λ) sampling interval still stands using our proposed method. Demonstrated by the experiment, the normalized root-mean-square error(NMSE) is 5.75%. Additionally, when the spatial sampling points are sampled randomly with 30% of the full sampling condition, this method can also restore and reconstruct the image with high quality. Due to the decrease of sampling points, the data volume can be reduced, which is beneficial for improving the scanning speed and alleviating the pressure of data transmission for near-field high resolution SAR imaging systems.

1-Bit Sar Imaging Assisted With Single-Frequency Threshold

One-Bit SAR Imaging Based on Single-Frequency Thresholds

Generalization of Single-Frequency Threshold Based on 1-Bit Quantization in Synthetic Aperture Radar

Lightweight SAR: A Two-Bit Strategy

One-Bit Radar Imaging Via Adaptive Binary Iterative Hard Thresholding

One-bit LFMCW Radar: Spectrum Analysis and Target Detection

1-Bit Radar Imaging Based on Adversarial Samples

Design of Adaptive Thresholds For One-Bit Radar Imaging Based on Adversarial Samples

One-bit splitting deceptive jamming against SAR

Enhanced 1-Bit Radar Imaging by Exploiting Two-Level Block Sparsity

Enhanced One-Bit SAR Imaging Method Using Two-Level Structured Sparsity to Mitigate Adverse Effects of Sign Flips

Refocusing of Moving Targets Based on Low-Bit Quantized SAR Data Via Parametric Quantized Iterative Hard Thresholding.

An Improved Ultrahigh-Resolution Stepped-Frequency Spaceborne SAR Imaging Algorithm

A 100MS/S 12-Bit Coarse-Fine SAR ADC with Shared Split-CDAC.

An Efficient Algorithm Based on CSA for THz Stepped-Frequency SAR Imaging

A Space-Borne SAR Azimuth Multi-Channel Quantization Method

Blocked Azimuth Spectrum Reconstruction Algorithm for Onboard Real-Time Dual-Channel SAR Imaging

One-Bit Radar Processing with Time-Varying Sampling Thresholds

Near-Field High-Resolution SAR Imaging with Sparse Sampling Interval

An Efficient Algorithm Based on Frequency Scaling for THz Stepped-Frequency SAR Imaging

Range-resolution Improvement for Spaceborne/airborne Bistatic Synthetic Aperture Radar Using Stepped-Frequency Chirp Trains