Abstract:This paper presents the design of a subsampling wideband 500MS/s 12Bit successive-approximation-register (SAR) analog-to-digital converter (ADC) with sub-2 radix split-capacitor array (SCA). The presented ADC is designed as a sub-ADC for a sample-and-hold-less (SAH-less) 8GS/s time-interleaved (TI) ADC. In addition to the required 16 ADC channels, two additional SAR lanes enable pseudorandom binary sequence (PRBS)-driven channel scrambling. A 1.81 radix is used to achieve 12Bit settling accuracy withing 70ps. Extra scaling capacitors in the SCA enable SAR reference voltage levels near the supply rails, significantly reducing the SCA switch sizes. The necessity of a comparator latch reset phase is eliminated at the cost of higher comparator power consumption by the adoption of a loop-unrolled comparator improving the SAR loop timing. Top-plate charge kickback into the input buffer, a challenge that occurs within TI ADCs, is largely eliminated by implementing an additional reset phase within the SAR algorithm and the use of a boosted input T-switch. SCA and time-interleaved channel mismatch effects are addressed by calibrating each sub-ADC to an extra reference-ADC. The industry grade ADC design, achieves a spurious free dynamic range (SFDR) of 72dB and signal to noise and distortion ratio (SNDR) of 54dB across the entire 4GHz frequency range. Designed in a 28nm CMOS process, each sub-ADC consumes 33mW from 1.8V and 1V. The input buffer frontend uses supply voltages of 2.5V and -1.3V. The overall power consumption of the overall TI ADC is 3W.

A 100MS/S 12-Bit Coarse-Fine SAR ADC with Shared Split-CDAC.

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

Design of an 8-Channel 12bits 1MSPS SAR ADC

A 10-Bit 250-KS/s 1.24-uW SAR ADC for IoT Sensors with Energy-Efficient Comparator.

A 14-Bit 500-Ms/s Pipelined-SAR ADC in 28-Nm CMOS with Foreground and Background Calibration

A 13 Bit 100 MS/s SAR ADC with 74.57 Db SNDR in 14-Nm CMOS FinFET.

A 6.94-Fj/conversion-step 12-Bit 100-Ms/s Asynchronous SAR ADC Exploiting Split-CDAC in 65-Nm CMOS

A 300ms/s 57.6db SNDR Single-Channel SAR ADC with Accelerated SAR Logic.

A 10b 250ms/s SAR ADC with Speed-Enhanced SAR Logic and Free Time More Than a Half of Sampling Period

A Multi-channel 12-Bits 100ms/s SAR ADC in 65nm CMOS

A Multi-channel 12-bits 100MS/s SAR ADC in 65nm CMOS.

A Low Power 10-Bit 100-Ms/s SAR ADC in 65nm CMOS

An 18-Bit SAR ADC with Mixed DAC and Capacitive Recombination Calibration

An 11-Bit 500 MS/s Two-Step SAR ADC with Non-Attenuated Passive Residue Transfer.

A 12-Bit 100ms/s SAR ADC with Equivalent Split-Capacitor and LSB-Averaging in 14-Nm CMOS FinFET

A 12 Bit 500 MS/s Sub-2 Radix SAR ADC for a Time-Interleaved 8 GS/s ADC in 28 nm CMOS

A 12-bit compact column-parallel SAR ADC with dynamic power control technique for high-speed CMOS image sensors

A 13-Bit 0.005-Mm2 40-Ms/s SAR ADC with Kt/c Noise Cancellation

A 4-Mw8-b 600-Ms/s 2-B-per-cycle SAR ADC with a Capacitive DAC

A 10-bit 200MS/s SAR ADC with reference buffer in 40nm CMOS

An 8-MS/s 16-bit SAR ADC With Symmetric Complementary Switching and Split Passive Reference Segmentation in 180-nm Process