Abstract:The electrostatic accelerometer is the key payload of many space missions, such as satellite gravity measurements, space gravitational experiments, with a typical precision requirement from nano-g to femto-g. The measurement error model analysis is an important issue for the electrostatic accelerometer with numerous error sources. The traditional method by theoretical analysis is complicated to evaluate the complete measurement error models quantitatively especially when the machining and assembly errors of the sensor head are considered. Limited by the earth gravity and seismic noise which is much higher than the intrinsic noise, the complete error model of electrostatic accelerometers can also hardly be tested on ground. In this paper, the method by using finite element analysis of the sensor head is studied. The simulation model for an electrostatic accelerometer sensor head is built, and the multi-conductor capacitance matrix data is simulated. The accuracy of the capacitance simulation is evaluated in three ways including the convergence check of the capacitance with the mesh size, the symmetry verification, and the sensitivity comparison with the theoretical model. Finally, the accelerometer measurement model is analyzed based on the simulation data, using the case of rotating installation misalignment of the upper electrode as an example. The measurement model and error items of one horizontal axis and one rotating axis are quantitatively evaluated. The method proposed in this paper provide a new effective approach to the measurement model analysis of the electrostatic accelerometers in complex working scenarios both in orbit and on ground, which could be helpful to enhance the performance and the efficiency of application.

Study on Loss of Performance in Inertial Sensors Due to Electrode Asymmetry

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

Analysis of mechanical errors of planar capacitive sensor for two dimensional displacement measurement

Finite Element Analysis for the Measurement Error of Electrostatic Accelerometer Due to the Electrode Misalignment

High Precision Electrostatic Inertial Sensor

Design and Test of the Electrostatic Actuation System of the Inertial Sensor for Space Gravitational Wave Detection

Using finite element simulation to evaluate charge measurement precision for space inertial sensors

Error Analysis of a Spherical Capacitive Sensor for the Micro-Clearance Detection in Spherical Joints

Electromechanical Inertial Sensors Test and Analysis Method Based on Identification Using Adaptive Noise Cancellation

Bias Stability Investigation of a Triaxial Navigation-Compatible Accelerometer with an Electrostatic Spring.

Modeling and Compensation of Cross-Axis Coupling in an Electrostatic Accelerometer for Testing the Equivalence Principle

A Space Inertial Sensor Ground Evaluation System for Non-Sensitive Axis Based on Torsion Pendulum

Identification and Compensation of Quadratic Terms of a Space Electrostatic Accelerometer.

Measurement of the Effect of a Thin Discharging Wire for an Electrostatic Inertial Sensor with a High-Quality-factor Pendulum

A MEMS Capacitive Inertial Sensor with Near Nanoscale Capacitance Plate Spacing

A New Structure of Test Mass for Ground-used Electrostatically Suspended Accelerometer

A Research on Calibration of Low-Precision Mems Inertial Sensors

Design And Test Of Displacement Transducer For An Electrode-Insulated Electrostatically Suspended Gyroscope

Design and Fabrication of a Differential Electrostatic Accelerometer for Space-Station Testing of the Equivalence Principle

Key Technologies and Progress of Inertial Sensors for Space Gravitational Wave Detection

Mechanical-electrostatic Coupling Research for MEMS Line Vibration Gyroscope