Abstract:Ultra-sensitive inertial sensors are one of the key components in satellite Earth's gravity field recovery missions and space gravitational wave detection missions. Low-noise capacitive position transducers are crucial to these missions to achieve the scientific goal. However, in actual engineering applications, the sensor head and electronics unit usually place separately in the satellite platform where a connecting cable is needed. In this paper, we focus on the stray-capacitance influences of coaxial cables which are used to connect the mechanical core and the electronics. Specially, for the capacitive transducer with a differential transformer bridge structure usually used in high-precision space inertial sensors, a connecting method of a coaxial cable between the transformer's secondary winding and front-end circuit's preamplifier is proposed to transmit the AC modulated analog voltage signal. The measurement and noise models including the stray-capacitance of the coaxial cable under this configuration is analyzed. A prototype system is set up to investigate the influences of the cables experimentally. Three different types and lengths of coaxial cables are chosen in our experiments to compare their performances. The analysis shows that the stray-capacitance will alter the circuit's resonant frequency which could be adjusted by additional tuning capacitance, then under the optimal resonant condition, the output voltage noises of the preamplifier are measured and the sensitivity coefficients are also calibrated. Meanwhile, the stray-capacitance of the cables is estimated. Finally, the experimental results show that the noise level of this circuit with the selected cables could all achieve 1-2 x 10(-7) pF/Hz(1/2) at 0.1 Hz.

Design and Test of the Electrostatic Actuation System of the Inertial Sensor for Space Gravitational Wave Detection

Electromechanical co-simulation analysis for contactless positioning and vibration isolation platform

Design and test of the actuation circuit of the inertial sensor for space gravitational wave detection based on hardware-in-the-loop simulation

Key Technologies and Progress of Inertial Sensors for Space Gravitational Wave Detection

High Precision Electrostatic Inertial Sensor

Actuation system of the inertial sensor for high-precision space missions using torsion pendulum

Torsion Pendulum Apparatus for Ground Testing of Space Inertial Sensor

Capacitive Sensing-Based Charge Measurement for Space Inertial Sensors

Core Payload of the Space Gravitational Wave Observatory: Inertial Sensor and Its Critical Technologies

Analysis and Design of an Electrostatic Space Accelerometer

High-Precision Inertial Sensor Charge Ground Measurement Method Based on Phase-Sensitive Demodulation

Using finite element simulation to evaluate charge measurement precision for space inertial sensors

Actuation system for inertial sensors in high-precision space missions using a torsion pendulum

Self-Triggered Fuzzy Data-Driven Learning-Based Test Mass Suspension Control for Space Inertia Sensor

Development and Experimental Investigation of a High-Precision Capacitive Displacement Transducer of the Inertial Sensor for TianQin

Eddy Current Damping of High Q Pendulums in Gravitational Wave Detection Experiments

Effect of the On-Board Residual Magnetism on Inertial Sensors

Hardware design of electrostatic levitation accelerometer control system

A Dynamic Model-Based Charge Measurement for Spatial Inertial Sensors

Investigation On Stray-Capacitance Influences Of Coaxial Cables In Capacitive Transducers For A Space Inertial Sensor

Design and Fabrication of a Differential Electrostatic Accelerometer for Space-Station Testing of the Equivalence Principle