Abstract:The electromechanical co-simulation method was used to simulate and analyze the 6-DOF (degrees of freedom) positioning and micro-vibration isolation functions of the platform in order to analyze the working performances of a contactless positioning and vibration isolation platform which works at space microgravity environment. The working principle of the contactless positioning and vibration isolation platform was introduced. The exciting unit, position measuring unit and acceleration measuring unit of the platform were made up by contactless biaxial actuators, biaxial position sensitive detectors and uniaxial accelerometers according to space symmetry layout scheme. The controller of the platform was designed based on position and acceleration feedback. Then the mechanical system simulation model and the closed-loop control system simulation model based on position and acceleration feedback was established by ADAMS and MATLAB/Simulink, respectively, which together set up the electromechanical co-simulation model of the platform. The positioning and vibration isolation performances of the platform were simulated by the co-simulation model. Results show that the 6-DOF displacement and angular displacement control errors of the platform are less than 10 μm and 2×10−5 rad respectively under small range positioning mode. The suppression efficiencies of the platform for 6-DOF direct sinusoidal disturbances with frequency range of 0.01−1 Hz and 1−100 Hz are 39−73 dB and 19−73 dB, respectively. The relative displacements between the floater and the stator are less than 1 mm during vibration isolation control process under vibration isolation mode.

Design and test of the actuation circuit of the inertial sensor for space gravitational wave detection based on hardware-in-the-loop simulation

Electromechanical co-simulation analysis for contactless positioning and vibration isolation platform

Hardware-in-the-Loop Simulation Method for Pico-satellite Attitude Determination and Control System

Core Payload of the Space Gravitational Wave Observatory: Inertial Sensor and Its Critical Technologies

Using finite element simulation to evaluate charge measurement precision for space inertial sensors

A 2-DOF drag-free control ground simulation system based on Stewart platform

Design of Hardware-In-Loop Simulation System for Unmanned Aerial Vehicle

Actuation system of the inertial sensor for high-precision space missions using torsion pendulum

Hardware design of electrostatic levitation accelerometer control system

Capacitive Sensing-Based Charge Measurement for Space Inertial Sensors

New LISA dynamics feedback control scheme: Common-mode isolation of test mass control and probes of test-mass acceleration

Development of a High-Accuracy Inertia Simulation System for Drive Joints of Space Station Transfer Arm

Parametrically driven inertial sensing in chip-scale optomechanical cavities at the thermodynamical limits with extended dynamic range

Investigation of Hardware-in-the-Loop Walking/Running Test with Spring Mass System

High-Precision Inertial Sensor Charge Ground Measurement Method Based on Phase-Sensitive Demodulation

Six-Degrees-of-Freedom Test Mass Readout via Optical Phase-Locking Heterodyne Interferometry

Generation of Accurate Translational Motion for Testing Inertial Sensors

A six-degree-of-freedom hardware-in-the-loop simulator for small spacecraft

Key technologies analysis and design of ultra-clean & ultra-stable spacecraft for gravitational wave detection

Analysis and Design of an Electrostatic Space Accelerometer