Abstract:Journal of Intelligent Material Systems and Structures, Ahead of Print. Hardware-in-the-loop (HIL) testing is a popular control system testing method because it bridges the gap between modeling/simulation and experiments. Instead of designing a full hardware-based experiment to validate the results of a simulation, the plant hardware can be replaced with an emulator device that responds to exogenous inputs and effectively emulates the dynamic behavior of a system. This approach can be more cost-effective and modular, since the emulated plant system can be modeled in a simulation environment, implemented on a simplified piece of hardware and changed quickly without having to fabricate new parts. This paper develops the hardware and control scheme for a certain type of HIL device called a dynamic load emulator that consists of a 1-DOF linear hydraulic dynamometer equipped with in-line sensing to measure both its own position and the force exerted on it by a device-under-test. This measured force is passed to a real-time model of the emulated dynamic system. The model outputs the emulated system position, and a closed-loop controller is used to emulate this position. The emulator controller incorporates both model-based feedforward and standard feedback PI control. This paper characterizes the dynamometer-based dynamic load emulator and its controller, determining its hardware limitations and validating its capabilities when experiencing a force input from a linear spring with known parameters. Additionally, this paper demonstrates the ability of the emulator to represent the dynamics of a 1-DOF robotic joint when actuated by a pair of fluidic artificial muscles (FAMs). The primary contribution of this work is to allow for more comprehensive testing of FAM configurations, topologies, and controllers for a wide range of parameters, because the same hardware can be used to emulate multiple systems. As a result, this work will lead to more cost-effective, time-efficient, and energy-efficient designs of robotic systems and the FAMs used to actuate them.

Investigation of Hardware-in-the-Loop Walking/Running Test with Spring Mass System

Development of a Novel Elastic Load-Carrying Device: Design, Modeling and Analysis

Modeling and simulation of humanoid lower limb based on Pneumatic Artificial Muscle

Simulation of Exoskeleton ZMP During Walking for Balance Control

Investigation of 3D Bipedal Spring-Loaded Inverted Pendulum Human Walking Model on Laterally Vibrating Surfaces in the Case of Phase Drift, Phase Pulling, and Synchronization

Designing Synergistic Walking of a Humanoid Single Leg Driven by Pneumatic Artificial Muscles: an Empirical Study

A spring-loaded inverted pendulum model for analysis of human-structure interaction on vibrating surfaces

Research on Mechanical Leg Structure Design and Control System of Lower Limb Exoskeleton Rehabilitation Robot Based on Magnetorheological Variable Stiffness and Damping Actuator

Design and test of the actuation circuit of the inertial sensor for space gravitational wave detection based on hardware-in-the-loop simulation

Biped Walking Based on Stiffness Optimization and Hierarchical Quadratic Programming

Analysis of the Disturbance Rejection Ability of a Passive Dynamic Walker with Hip Spring

Mechanical Design and Control System Development of a Rehabilitation Robotic System for Walking With Arm Swing

Human-in-the-Loop Control of Robotic Leg Prostheses with Sensory Feedback

A Gait Simulation and Evaluation System for Hip Disarticulation Prostheses

Design and sequential jumping experimental validation of a musculoskeletal bipedal robot based on the spring-loaded inverted pendulum model

Simulation of human gait with body weight support: benchmarking models and unloading strategies

A Balance Rehabilitation Gait for Human and Lower Extremity Exoskeleton System to Overcome the Instability Caused by Gravity

Design and analysis of plantar hydraulic control device for body weight support treadmill training

Hardware-in-the-loop dynamic load emulation of robotic systems actuated by fluidic artificial muscles

The Optimization of Spring Stiffness for Passive Dynamic Walker.

A Dynamic Bipedal Walking Method Using Coupled Elastic Actuation