Abstract:Despite numerous studies focused on the hydrothermal (HT) synthesis of fly ash zeolites (FAZs), this method still has many limitations, the main of which is the low yield of zeolites. Hydrothermally synthesized zeolites are typically multiphase and exhibit low purity, which limits their applicability. Pure-phase zeolites have been primarily prepared from filtrates after alkaline mineralization of fly ashes, not directly in suspension. In addition, the published methodologies have not been tested in a wider set of samples, and thus their reproducibility is not confirmed. The aim of the study is to propose a reproducible methodology that overcomes the mentioned limitations. The influence of the Si/Al ratio (1.3:1–1:2), the type and concentration of the activator (2/4 M NaOH/KOH/LiOH), the reagent (30% LiCl), the duration (24–168 h), and the temperature (50–180 °C) of the synthesis phases were studied. The sequence of the synthesis phases was also optimized, depending on the type of heat transfer. The fly ashes were analyzed by wavelength-dispersive X-ray fluorescence (WD XRF), flame atomic absorption spectrometry (F-AAS), and X-ray diffraction (XRD). The energy intensity of the synthesis was reduced through the application of unique microwave digestion technology. Both microwave and combined (microwave and convection) syntheses were conducted. FAZs were identified and quantified by XRD analysis. This study presents a three-stage (TS) hydrothermal synthesis of pure-phase sodalite in suspension. Sodalite (>99 wt.%) was prepared from nine fly ashes under the following conditions: I. microwave phase: 120 °C, 150 min, solid-to-liquid ratio (S/L) 1:5, Si/Al ratio 1:1.5, and 4 M NaOH; II. convection phase: 120 °C, 24 h, S/L 1:40, and the addition of 30 mL of 30% LiCl; and III. crystallization: 70 °C for 24 h. The formation of rhombododecahedral sodalite crystals was confirmed by scanning electron microscope (SEM) images.

Effect of Temperature on the Synthesis of Sodalite by Crystal Transition Process

Hydrothermal Synthesis of Sodalite from Coal Fly Ash and Its Property Characterization

Influences of crystallization time, batch molar ratios Al2O3/SiO2 and Na2O/SiO2 on particulate properties of sodalite crystals prepared under room-temperature conditions

Controlling Crystal Transformation Between Zeolite Zsm-5 and Mordenite Without Organic Structure-Directing Agent

A facile recrystallization strategy for fabrication of nanocrystalline microspheres of sulfatic sodalite with high thermal stability

Sonohydrothermal synthesis of zeolite A and its phase transformation into sodalite

Low-temperature Synthesis of Bi4Ti3O12 Nanocrystals by Hydrothermal Method

Synthesis of Sodalite Zeolite from Alkaline Fusion of Kaolin and Crystallization at Low Temperature and Ambient Pressure

The effects of dry grinding and wet grinding on synthesizing iodosodalite

Study on the Effect of Temperature on the Crystal Transformation of Microporous Calcium Silicate Synthesized of Extraction Silicon Solution from Fly Ash

Preparation of sodalite at room temperature with varying hydrogel Al2O3/SiO2 molar ratio for enhanced Cd2+ adsorption

Microwave-Assisted Hydrothermal Synthesis of Pure-Phase Sodalite (>99 wt.%) in Suspension: Methodology Design and Verification

Evolution of Oh Groups in Diopside and Feldspars with Temperature

Determining the Role of Water Molecules in Sodalite Formation Using the Vapor Phase Crystallization Method

Effects of Water Amount and Ph on the Crystal Behavior of a TiO2 Nanocrystalline Derived from a Sol–Gel Process at a Low Temperature

Control of crystallization rate and morphology of zeolite silicalite-1 in solvent-free synthesis

Effect of Calcination Temperature on Crystal Structure and Photocatalytic Prop- Erty of TiO2/Diatomite Nanoparticles

Sintering behaviour and structure-thermal stability relationships of alkali-doped ternesite

Effects of Heat Treatment on Crystal Structure and Reactivity of Sericite

Effects of Synthesizing Temperature on Formation of Mullite Whiskers in Molten Sodium Sulfate Medium

Effects of formulation and temperature on synthesis of cordierite from serpentine