Abstract:In this study, a new heat dissipation device with a composite heat sink of a loop heat pipe (LHP) system was evaluated for efficient cooling of electronic components. To improve the heat dissipation ability of the high heat flux chip and its local hot spot area, LHP, which had a gas-liquid phase change as the main mechanism of heat dissipation, was selected to remove heat. The experimental results showed that the average temperature performance was improved after the graphene copper foil heat sink was fitted, and the maximum temperature under the heat loads of 80 W, 90 W, 100 W, and 120 W was reduced by 3.8 degrees C, 5.7 degrees C, 6.5 degrees C, and 7.7 degrees C, respectively, compared with without a heat sink. The hot spot temperature increased linearly with an increase in the inlet water temperature. Increasing the ambient temperature within a certain range had little effect on the heat-dissipation effect of the hot spots. To interpret the experimental results, the hot spot heat transfer performance of the evaporation section of the LHP with a composite heat sink was set up by the equivalent thermal resistance model. The CFD simulated results were in good agreement with the experimental values. This indicated that the heat sink significantly reduced the hot spot temperature and improved the cooling uniformity largely. When the transverse thermal conductivity of the heat sink is sufficiently high, the increase in longitudinal thermal conductivity is more effective in reducing the hot spot temperature than the transverse thermal conductivity. Moreover, it has been suggested that the hot spots and heating power play a major role in the actual electronic structure and heat dissipation design. In summary, the study proposes a valuable method for improving the uniform cooling of chips, which was conducive to the heat management of the system.

Effect of pore structure on heat transfer performance of lotus-type porous copper heat sink

Experimental Study on Heat Transfer Performance of Lotus-Type Porous Copper Heat Sink

Heat transfer performance of lotus-type porous copper heat sink with liquid GaInSn coolant

Theoretical Study on Heat Transfer Performance of Directioanlly Solidified Porous Copper Heat Sink

The Effect of Process Parameters on the Pore Structure of Lotus-Type Porous Copper Fabricated via Continuous Casting

Effect of structural characteristics on the natural convective heat transfer performance of copper foam

Enhancement of the heat transfer for directionally solidified porous copper heat sinks by cutting into sections

Simulation on Heat Transfer Performance of Directionally Solidified Porous Copper Heat Sink

Optimizing the Pore Structure of Lotus-Type Porous Copper Fabricated by Continuous Casting

Key factors affecting the boiling heat transfer coefficient of FC-72 in saturated pool boiling using lotus-type porous copper

Fabrication of Lotus-Type Porous Micro-Channel Copper by Single-Mold Gasar Technique

Evolution of Porosity in Lotus-Type Porous Copper Fabricated by Continuous Casting Technique

Fabrication of Lotus-Type Porous Silicon by Unidirectional Solidification in Pressurized Hydrogen Atmosphere

Study of Heat Dissipation Characteristics of Loop Heat Pipe with Heat Sink of Composite Material

Heat transfer coefficient and pressure drop of water flow boiling in porous open microchannels heat sink

Effects of structure characteristics and fluid on the effective thermal conductivity of sintered copper foam

Effect of Porous Substrates on Thermohydraulic Performance Enhancement of Double Layer Microchannel Heat Sinks

Thermal Performance of the Multilayered Honeycomb Microchannel Heat Sink

Cooling Behavior In A Novel Heat Sink Based On Multilayer Staggered Honeycomb Structure

Fabrication Of Porous Structures On Microchannel Surfaces By Laser Micromilling For Enhanced Microchannel Heat Sinks

Study on heat dissipation performance of a lattice porous structures under jet impingement cooling