Abstract:Microstructure formation of a hypo-eutectic Al-11Cu (atom percent) alloy during solidification after laser melting has been studied by transmission electron microscopy (TEM). The evolution of the solid-liquid-interface velocity, VSL, during the solidification process has been determined from direct observation by in-situ TEM. This enabled correlating VSL with development of four distinct microstructure zones. Crystal growth mode transitions from planar to cellular, cellular to dendritic, dendritic to cellular, and cellular to planar, have been observed for the accelerating solid-liquid-interface. The transition from coupled two-phase growth to the single-phase growth occurred for VSL = Va = (0.80±0.05) m/s, where Va is the velocity of absolute stability, at the onset of banded morphology grain formation. The in-situ and post-mortem TEM uniquely permitted determination of the non-equilibrium solidus for the rapidly solidifying Al-11Cu alloy. Experimental evidence for solute clustering and chemical ordering tendencies at length scales on the order of ≤ 5nm has been detected in the single-phase regions of the banded grains. The structural features of the single-phase bands have been interpreted as signatures of 'frozen in' configurations present in the liquid boundary layer adjacent to the growing crystal, which has a width of about 3nm. The nano-scale spatiotemporal resolution experimental TEM studies performed here provided quantitative metrics, e.g. the solidification interface velocity dependent solute concentration of the α-Al phase and the near-atomic scale structure in the single-phase bands, that are uniquely suitable for comparison with theory and model predictions for solidification microstructure development in multicomponent alloys after laser melting.

Investigation of the Origin of Anomalous Eutectic Formation by Remelting Thin-Gauge Samples of an Ag-Cu Eutectic Alloy

Formation Mechanism of Anomalous Eutectics in Highly Undercooled Ag-39.9 At%Cu Alloys

Remelting-induced Anomalous Eutectic Formation During Solidification of Deeply Undercooled Eutectic Alloy Melts

Cellular Growth of Lamellar Eutectics in Undercooled Ag–Cu Alloy

Non-equilibrium solidification of bulk undercooled Ni–P eutectic alloys

Anomalous Eutectic Formation in Undercooled Ni−P Eutectic Alloy

Mechanism of Anomalous Eutectic Formation in the Solidification of Undercooled Ni–Sn Eutectic Alloy

Microstructure Refinement Mechanism of Undercooled Cu55Ni45 Alloys

Solidification behavior and microstructure of Ag–Cu eutectic alloy at different sub-rapid cooling rates

The Formation Mechanism of Anomalous Eutectic in Highly Undercooled Ni-Sn Eutectic Alloy

Abnormal Dynamic Behavior And Structural Origin Of Cu-Ag Eutectic Melt

Anomalous Eutectic Formation in the Solidification of Undercooled Co–Sn Alloys

Evolution Mechanism of Rapid Solidification Microstructure of an Undercooled Copper-Based Single Phase Alloy

Solidification of Undercooled Ag–Cu Eutectic Alloy with the Sb Addition

Anomalous eutectics in intermediately and highly undercooled Ni-29.8at.%Si eutectic alloy

Interface structure and energy in Cu–71.8 wt.% Ag

Critical Cooling Rate and Microstructure Evolution of Cu-Based Bulk Amorphous Alloy

Thermodynamic description of metastable fcc/liquid phase equilibria and solidification kinetics in Al-Cu alloys

SOLIDIFICATION BEHAVIOR AND MICROSTRUCTURE EVOLUTION OF Fe83B17 EUTECTIC ALLOY UNDER HYPER-UNDERCOOLING

Interface velocity dependent solute trapping and phase selection during rapid solidification of laser melted hypo-eutectic Al-11at.%Cu alloy

Metastable Structures of Immiscible System Induced by Mechanical Alloying