Abstract:High inrush current severely threats the safe operation of the power system and transformers, which may lead to mal-operation of overcurrent protection device, internal short-circuit fault in transformers. Phase-controlled switching technology is an alternative method to reduce inrush current effectively by controlling the front-mounted circuit breaker (CB) to break or make at the predetermined phase angles of current or voltage. In this paper, a new simplified phase-controlled switching strategy is proposed for three-phase unloaded transformer with Y-connected windings in the primary side, which can limit the inrush current under 46.7% of the captured maximum inrush current. Meanwhile, this strategy is independent on the residual fluxes in the iron cores. The optimal making angle is obtained by theoretical analysis based on an equivalent circuit model of unloaded transformer. The comparison of the proposed method and the random switching approach is also presented with considering residual flux. A simulation model is established to calculate the amplitudes of inrush currents against various residual fluxes when using the proposed phase-controlled switching strategy and random switching method. The simulation results show that the proposed strategy can limit the inrush current under a low value. A test platform with high and low voltage instruments is built and some measurements are carried out. The experimental results are in good agreement with the theoretical analysis and simulation results, which verifies the effectiveness and practicability of the proposed strategy.

Improved Flux-Controlled VFCV Strategy for Eliminating and Measuring the Residual Flux of Three-Phase Transformers

Flux-Controlled Methods for Demagnetization of Transformer Iron Core: a Comparative Study

A Novel Strategy for Reducing Inrush Current of Three-Phase Transformer Considering Residual Flux.

Residual Flux Measuring Method on the Core ofFerromagnetic Components Based on Alternating Polarity DCVoltage Source

Residual Flux Estimation Method for Three-Phase Transformers Without Zero-Sequence Circuit on the Switch-off Side

Study on Residual Flux Evaluation Method Based on Variable-Regional Integral During the Voltage Attenuation Process

Analysis on Method of Calculating Transformer Residual Flux by Using the Integration of Port-Voltage Waveform and Its Implementation

A New Method to Measure the Residual Flux by Magnetic Sensors and a Finite-Element Model.

Mitigating the Inrush Current of V/V Transformers Using Railway Conditioners

Three-Phase Transformer Inrush Current Reduction Strategy Based on Prefluxing and Controlled Switching

Control strategy of transformer coupling solid state fault current limiter and its experimental study with capacitance load

Design and Optimization of Novel Doubly-Fed Consequent-Pole Flux Reversal Machine

In-Situ Measurement and Investigation of Winding Loss in High-Frequency Cored Transformers Under Large-Signal Condition

Improved Model-Predictive-Flux-Control Strategy for Three-Phase Four-Switch Inverter-Fed Flux-Reversal Permanent Magnet Machine Drives

Transformer Inrush Mitigation for Dynamic Voltage Restorer Using Direct Flux Linkage Control

Improved Identification Method and Fault Current Limiting Strategy for Commutation Failure in LCC-HVDC

Virtual Flux in a Three-Level Pulse Width Modulation Rectifier

A Novel Scheme Based on Flux Restraint Theory Used in Distinguishing Inrush Currents for UHV Transformers

A Simplified Phase-Controlled Switching Strategy for Inrush Current Reduction

A Novel Method for CVT Transient Transform Characteristics Improvement Integrated With Digital Filter Suppressing Voltage Oscillation

Improved Low-Frequency Transformer Model Based on Jiles–Atherton Hysteresis Theory